Nissan Juke Service and Repair Manual : P158A ECM

DTC Logic

*: Since this DTC is detected when G sensor calibration is incomplete, there


*: Since this DTC is detected when G sensor calibration is incomplete, there is not replacement parts.

1.PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.

2. Turn ignition switch ON.

3. Turn ignition switch OFF and wait at least 10 seconds.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn ignition switch ON.

2. Check DTC.

Is DTC detected? YES >> Proceed to EC-354, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.PERFORM CALIBRATION OF G SENSOR

Perform calibration of G sensor. Refer to EC-138, "Work Procedure".

>> INSPECTION END

    P1574 ASCD vehicle speed sensor
    Description The ECM receives two vehicle speed sensor signals via CAN communication line. One is sent from combination meter, and the other is from TCM (Transmission control module). The ECM uses ...

    P159A, P159C, P159D G sensor
    For M/T models : DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure ...

    Other materials:

    Component parts
    Component Parts Location LHD models 1. Multi display unit* Refer to DMS-3, "Component Parts Location". 2. ABS actuator and electric unit (control unit) Refer to BRC-9, "Component Parts Location" (without ESP), BRC-97, "Component Parts Location" (with ESP). ...

    C1113, C1145, C1146 yaw rate/side/decel g sensor
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CONSULT ...

    Final drive
    Exploded View 1. Shim 2. Differential side bearing outer race (transaxle case side) 3. Differential side bearing inner race (transaxle case side) 4. Final gear 5. Differential case 6. Differential side bearing inner race (clutch housing side) 7. Differential side bearing outer race ( ...