Nissan Juke Service and Repair Manual : P0746 pressure control solenoid A
DTC Logic
DTC DETECTION LOGIC
NOTE
:
DC stands for "DRIVING CYCLE" and indicates a series of driving cycle of
"Ignition switch OFF → ON → driving
→ OFF".
DTC CONFIRMATION PROCEDURE
CAUTION:
Be careful of the driving speed.
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
1. Start the engine.
2. Drive the vehicle.
3. Maintain the following conditions for 10 seconds or more.
Selector lever : “D” position Accelerator pedal position : 0.1/8 or more Vehicle speed : 40 km/h (25 MPH) or more
4. Stop the vehicle.
5. Check the first trip DTC.
Is “P0746”detected? YES >> Go to TM-423, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK LINE PRESSURE SOLENOID VALVE
1. Turn ignition switch OFF.
2. Disconnect the CVT unit connector.
3. Check the line pressure solenoid valve. Refer to TM-423, "Component Inspection (Line Pressure Solenoid Valve)" Is the inspection result normal? YES >> GO TO 2.
NO >> Repair or replace the malfunctioning parts.
2.CHECK LINE PRESSURE
Perform the line pressure test. Refer to TM-382, "Work Procedure".
Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
NO >> Repair or replace the malfunction items.
Component Inspection (Line Pressure Solenoid Valve)
1.CHECK LINE PRESSURE SOLENOID VALVE
Check the resistance between the CVT unit connector terminal and ground.
Is the inspection result normal? YES >> INSPECTION END
NO >> There is a malfunction of the line pressure solenoid valve. Replace the transaxle assembly. Refer to TM-508, "Removal and Installation".
P0744 torque converter
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Be careful of the driving speed. 1.PREPARATION BEFORE OPERATION 1 If another "DTC CONFIRMATION PROCEDURE" occurs jus ...P0846 transmission fluid pressure SEN/SW B
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Be careful of the driving speed. 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just bef ...Other materials:
Precautions on cruise control
• If the cruise control system malfunctions, it will cancel automatically.
The CRUISE indicator light on the meter panel will then blink to warn the driver.
• If the engine coolant temperature becomes excessively high, the cruise control
system will cancel automatically.
• If ...
Diagnosis and repair workflow
Gasoline engine models
GASOLINE ENGINE MODELS : Work Flow
OVERALL SEQUENCE
DETAILED FLOW
1.PRELIMINARY INSPECTION
Perform the preliminary inspection. Refer to CHG-17, "Inspection Procedure".
Models with battery current sensor>>GO TO 2.
Models without battery current sens ...
Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE:
• Before removing and installing any control units, first turn the ignition
switch to the LOCK position, then disconnect
both battery cables.
• After finishing work, confirm that all control unit connectors are connected
properly, then re-connect both
battery cables.
• Always use CONS ...