Nissan Juke Service and Repair Manual : P0713 transmission fluid temperature sensor A

DTC Logic

DTC CONFIRMATION PROCEDURE

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE

1. Start the engine.

2. Maintain the following condition for 10 seconds or more.

Vehicle speed : 20 km/h (12 MPH) or more

3. Stop the vehicle.

4. Check the first trip DTC.

Is “P0713” detected? YES >> Go to TM-406, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK CIRCUIT BETWEEN TCM AND CVT UNIT (PART 1)

1. Turn ignition switch OFF.

2. Disconnect the TCM connector and the CVT unit connector.

3. Check the continuity between the TCM harness connector terminals and the CVT unit harness connector terminals.

Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace malfunctioning part.

2.CHECK CIRCUIT BETWEEN TCM AND CVT UNIT (PART 2)

1. Turn ignition switch ON.

2. Check the voltage between the TCM harness connector terminal and ground.


Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace malfunctioning part.

3.CHECK CVT FLUID TEMPERATURE SENSOR

Check the CVT fluid temperature sensor. Refer to TM-409, "Component Inspection (CVT Fluid Temperature Sensor)".

Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

NO >> Repair or replace the malfunctioning parts.

Component Inspection (CVT Fluid Temperature Sensor)

1.CHECK CVT FLUID TEMPERATURE SENSOR

Check resistance between the CVT unit connector terminals.

Is the inspection result normal?


Is the inspection result normal? YES >> INSPECTION END

NO >> There is a malfunction of the CVT fluid temperature sensor. Replace the transaxle assembly.

Refer to TM-508, "Removal and Installation".

    P0712 transmission fluid temperature sensor A
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for a ...

    P0715 input speed sensor A
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Be careful of the driving speed. 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just befor ...

    Other materials:

    Brake piping
    Front : Exploded View WITHOUT ESP 1. Brake tube 2. ABS actuator and electric unit (control unit) 3. Connector 4. Connector bracket 5. Master cylinder assembly 6. Brake booster 7. Lock plate 8. Brake hose 9. Union bolt 10. Copper washer A. To rear brake tube : N·m (kg-m, ft-lb) ...

    On Board Diagnostic (OBD) System of Engine and CVT
    The ECM has an on board diagnostic system. It will light up the malfunction indicator lamp (MIL) to warn the driver of a malfunction causing emission deterioration. CAUTION: • Be sure to turn the ignition switch OFF and disconnect the negative battery cable before any repair or inspection ...

    Diagnosis Procedure
    WARNING: • Before servicing, turn ignition switch OFF, disconnect battery negative terminal and wait at least 3 minutes. (To discharge backup capacitor.) • Never use unspecified tester or other measuring device. 1.CHECK HARNESS CONNECTOR Check the harness connector. Is the inspection res ...