Nissan Juke Service and Repair Manual : P0643 sensor power supply

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.

2. Turn ignition switch ON.

3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 8 V at idle.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE

1. Start engine and let it idle for 1 second.

2. Check DTC.

Is DTC detected? YES >> Proceed to EC-307, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK SENSOR POWER SUPPLY

1. Turn ignition switch ON.

2. Check the voltage between ECM harness connector and ground.

Is the inspection result normal?


Is the inspection result normal?

YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

NO >> GO TO 2.

2.CHECK SENSOR POWER SUPPLY ROUTING CIRCUIT FOR SHORT

1. Turn ignition switch OFF.

2. Check harness for short to power and to ground, between the following terminals.

*1: LHD models or RHD with CVT models


*1: LHD models or RHD with CVT models *2: RHD with M/T models

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace error-detected parts.

3.CHECK COMPONENT

S

Check the following.

• Refrigerant pressure sensor Refer to EC-423, "Diagnosis Procedure".

• Crankshaft position sensor Refer to EC-273, "Component Inspection".

• Throttle position sensor Refer to EC-203, "Component Inspection".

• Accelerator pedal position sensor Refer to EC-387, "Component Inspection".

Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

NO >> Replace malfunctioning component.

    P062B ECM
    Description This DTC is detected when the ECM-integrated injector driver unit has a malfunction. For injector driver unit, refer to EC-31, "ECM". DTC Logic DTC DETECTION LOGIC DTC C ...

    P0850 PNP switch
    Description For CVT models, transmission range switch is turn ON when the selector lever is P or N. For M/T models, park/neutral position (PNP) range switch is ON when the selector lever is Ne ...

    Other materials:

    Manual air conditioner (if so equipped)
    1. Air intake lever (Outside air circulation /Air recirculation ) 2. Air flow control dial 3. Fan speed control dial 4. A/C (Air Conditioner) button 5. Temperature control dial 6. Rear window defroster button (See “Rear window and outside mirror defroster switch” .) To turn off the he ...

    P1701 TCM
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2.CHECK DTC DETECTION 1. S ...

    P2002 diesel particulate filter
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK DIESEL PARTICULATE FILTER Refer to EC-995, "Component Inspection". OK or NG OK >> INSPECTION END NG >> GO TO 2. 2.REPLACE DIESEL PARTICULATE FILTER 1. Replace diesel particulate filter. 2. Perform ???Dies ...