Nissan Juke Service and Repair Manual : P0638 electric throttle control actuator function
DTC Logic
DTC DETECTION LOGIC
NOTE
:
If DTC P0638 is displayed with DTC P0120 or P2100, first perform trouble
diagnosis for DTC P0120 or P2100.
Refer to EC-909, "DTC Logic" (P0120), EC-997, "DTC Logic" (P2100).
Diagnosis Procedure
1.CHECK ELECTRIC THROTTLE CONTROL ACTUATOR
Perform EC-910, "Component Inspection" (P0120), EC-998, "Component Inspection" (P2100).
Is the inspection result normal? YES >> GO TO 3.
NO >> GO TO 2.
2.REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
1. Replace electric throttle control actuator.
2. Perform EC-973, "Special Repair Requirement".
>> INSPECTION END
3.CHECK INTERMITTENT INCIDENT
Refer to GI-42, "Intermittent Incident".
>> INSPECTION END
Special Repair Requirement
1.PERFORM THROTTLE VALVE CLOSED POSITION LEARNING
Refer to EC-882, "Work Procedure".
>> END
P062B ECM
DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.INSPECTION START 1. Turn ignition switch ON. 2. Erase DTC. 3. Turn ignition switch OFF and wait for 20 seconds. 4. Turn ignition switch ON ...P0641 sensor power supply
DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK GROUND CONNECTION 1. Turn ignition switch OFF. 2. Check ground connection E38. Refer to Ground Inspection in GI-44, "Circuit Ins ...Other materials:
B210C starter control relay
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B210C is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to
PCS-30, "DTC Logic".
• When IPDM E/R power supply voltage is low (Approx. 7 - 8 V for about 1
second), the DTC B210C may be
detected.
DTC ...
Brake and clutch (if so equipped) fluid
For additional brake and clutch fluid information, see “Capacities and recommended
fuel/lubricants” of this manual.
WARNING
• Use only new fluid from a sealed container. Old, inferior or contaminated
fluid may damage the brake and clutch systems. The use of improper fluids can damage
t ...
Intelligent key warning buzzer
Component Function Check
1.CHECK FUNCTION
1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III.
2. Select “OUTSIDE BUZZER” in “ACTIVE TEST” mode.
3. Check that the function operates normally according to the following
conditions.
Is the inspection result normal?
YES >> Intelligent ...