Nissan Juke Service and Repair Manual : P062f eeprom

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

1. Start the engine.

2. Check the first trip DTC.

Is “P062F” detected? YES >> Go to TM-393, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK INTERMITTENT INCIDNT

Refer to GI-42, "Intermittent Incident".

Is the inspection result normal? YES >> Replace the TCM. Refer to TM-490, "Removal and Installation".

NO >> Repair or replace the malfunctioning parts.

    U1119 lost comm (multi-display)
    Description CAN (Controller Area Network) is a serial communication line for real-time application. It is an on-vehicle multiplex communication line with high data communication speed and excellen ...

    P0705 transmission range switch A
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Be careful of the driving speed. 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just befor ...

    Other materials:

    Operation
    AUTOMATIC SPEED CONTROL DEVICE (ASCD) AUTOMATIC SPEED CONTROL DEVICE (ASCD) : Switch Name and Function SWITCHES AND INDICATORS 1. CRUISE indicator 2. SET indicator 3. CANCEL switch 4. RES / + switch 5. SET / − switch 6. Speed limiter MAIN Switch 7. ASCD MAIN switch A. On the co ...

    Information display (ASCD)
    Component Function Check 1.CHECK INFORMATION DISPLAY 1. Start engine. 2. Press ASCD MAIN switch. 3. Drive the vehicle at more than 30 km/h (20 MPH) CAUTION: Always drive vehicle at a safe speed. 4. Press SET/ACCELERATE or SET/COAST switch. 5. Check that the readings of the speedometer show t ...

    Power supply and ground circuit
    A/C auto AMP. : Diagnosis Procedure 1.CHECK SYMPTOM Check symptom (A or B). Which symptom is detected? A >>GO TO 2. B >>GO TO 5. 2.CHECK FUSE 1. Turn ignition switch OFF. 2. Check 10A fuse (No. 3, located in fuse block (J/B)]. NOTE: Refer to PG-22, "Fuse, Connector ...