Nissan Juke Service and Repair Manual : P0611 ECM protection
Description
This DTC is detected when the ECM protective function is activated due to an extreme temperature increase in ECM, resulting from severe conditions such as heavy load driving.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
This DTC is displayed as protection function history. If no malfunction is detected after the diagnosis, the customer must be informed of the activation of the protection function.
>> Proceed to EC-305, "Diagnosis Procedure".
Diagnosis Procedure
1.INSPECTION START
1. Perform DTC confirmation procedure. Refer to EC-302, "DTC Logic".
2. Check 1st trip DTC.
Is DTC P0605 detected? YES >> Proceed to EC-302, "Diagnosis Procedure".
NO >> Explain the customer about the activation of the protection function.
P0607 ECM
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC. Is DTC detected? YES >> Proceed to EC-304, &quo ...P062B ECM
Description This DTC is detected when the ECM-integrated injector driver unit has a malfunction. For injector driver unit, refer to EC-31, "ECM". DTC Logic DTC DETECTION LOGIC DTC C ...Other materials:
P1556, P1557 battery temperature
sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
1. Turn ignition switch OFF and wait at lest 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm ...
Refilling
1. IInstall reservoir tank if removed, and install radiator drain plug.
CAUTION:
Be sure to clean drain plug and install with new O-ring.
Radiator drain plug : Refer to CO-17, "Exploded View".
• If water drain plugs on cylinder block are removed, close and tighten them.
Refer to EM ...
Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE:
• Before removing and installing any control units, first turn the ignition
switch to the LOCK position, then disconnect
both battery cables.
• After finishing work, confirm that all control unit connectors are connected
properly, then re-connect both
battery cables.
• Always use CONS ...