Nissan Juke Service and Repair Manual : P0606 ECM
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
1.INSPECTION START
1. Turn ignition switch ON.
2. Erase DTC.
3. Turn ignition switch OFF and wait for 20 seconds.
4. Turn ignition switch ON and perform the self-diagnosis.
Is the DTC P0606 displayed again? YES >> GO TO 2.
NO >> INSPECTION END
2.REPLACE ECM
1. Replace ECM.
2. Go to EC-879, "Work Procedure".
>> INSPECTION END
P0575 ASCD steering switch
DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK ASCD STEERING SWITCH CIRCUIT 1. Check ASCD steering switch circuit. ASCD steering switch>>Refer to EC-1011, "Component Fun ...P060A ECM
DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.INSPECTION START 1. Turn ignition switch ON. 2. Erase DTC. 3. Turn ignition switch OFF and wait for 20 seconds. 4. Turn ignition switch ON ...Other materials:
Vehicle does not enter 4WD mode
Description
Vehicle does not enter 4-wheel drive mode even though 4WD warning lamp turned
to OFF.
Diagnosis Procedure
1.CHECK 4WD WARNING LAMP
Turn the ignition switch ON.
Does 4WD warning lamp turn ON?
YES >> GO TO 2.
NO >> Proceed to diagnosis procedure. Refer to DLN-80, & ...
ESP off switch
Component Function Check
1.CHECK ESP OFF SWITCH OPERATION
Check that ESP OFF indicator lamp in combination meter turns ON/OFF when ESP
OFF switch is operated.
Is the inspection result normal?
YES >> INSPECTION END
NO >> Proceed to diagnosis procedure. Refer to BRC-210, &qu ...
Center stem assembly
Exploded View
1. Filler plug
2. Gasket
3. Drain plug
4. Breather tube
5. Clip
6. Breather hose
7. Breather
8. sub-harness clip
9. sub-harness
10. Rear cover
11. Center stem
12. Side bearing (right)
13. Side bearing adjusting shim (right)
14. Side oil seal (right)
15. Connec ...