Nissan Juke Service and Repair Manual : P0605 ECM

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE


DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION A

1. Turn ignition switch ON.

2. Check 1st trip DTC.

Is 1st trip DTC detected? YES >> Go to EC-683, "Diagnosis Procedure".

NO >> GO TO 3.

3.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION B

1. Turn ignition switch ON and wait at least 1 second.

2. Turn ignition switch OFF, wait at least 10 seconds, and then turn ON.

3. Check 1st trip DTC.

Is 1st trip DTC detected? YES >> Go to EC-683, "Diagnosis Procedure".

NO >> GO TO 4.

4.PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION C

1. Turn ignition switch ON and wait at least 1 second.

2. Turn ignition switch OFF, wait at least 10 seconds, and then turn ON.

3. Repeat step 2 for 32 times.

4. Check 1st trip DTC.

Is 1st trip DTC detected? YES >> Go to EC-683, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.INSPECTION START

1. Erase DTC.

2. Perform DTC CONFIRMATION PROCEDURE.

See EC-683, "DTC Logic".

Is the 1st trip DTC P0605 displayed again? YES >> GO TO 2.

NO >> INSPECTION END

2.REPLACE ECM

1. Replace ECM.

2. Perform EC-541, "Work Procedure".

>> INSPECTION END

    P0603 ECM
    Description ECM has the memory function of the DTC memory, the air-fuel ratio feedback compensation value memory, the Idle Air Volume Learning value memory, etc. even when the ignition switch is tu ...

    P0607 ECM
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Turn ignition switch ON. 2. Check DTC. Is DTC detected? YES >> Proceed to EC-685, &quo ...

    Other materials:

    F.M.V.S.S./C.M.V.S.S. certification label
    The Federal/Canadian Motor Vehicle Safety Standards (F.M.V.S.S./C.M.V.S.S.) certification label is affixed as shown. This label contains valuable vehicle information, such as: Gross Vehicle Weight Ratings (GVWR), Gross Axle Weight Rating (GAWR), month and year of manufacture, Vehicle Identif ...

    Driver side power window does not operate
    Diagnosis Procedure 1.CHECK FRONT POWER WINDOW MOTOR (DRIVER SIDE) Check front power window motor (driver side). Refer to PWC-26, "DRIVER SIDE : Component Function Check". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace the malfunctioning pa ...

    P1650 starter motor relay 2
    Description ECM controls ON/OFF state of the starter relay, according to the engine and vehicle condition. Models with no Intelligent Key System transmit a control signal directly to IPDM E/R. On the other hand, models with the Intelligent Key System transmit a control signal to IPDM E/R by w ...