Nissan Juke Service and Repair Manual : P0501, P2159 vehicle speed sensor
Description
ECM receives a rear wheel sensor signal from ABS actuator and electric unit (control unit) via CAN communication to switch combustion for the direct injection gasoline system. For the direct injection gasoline system, refer toEC-48, "DIRECT INJECTION GASOLINE SYSTEM : System Description".
DTC Logic
DTC DETECTION LOGIC
NOTE
:
If DTC P0501 or P2159 is displayed with DTC UXXXX, first perform the trouble
diagnosis for DTC UXXXX.
Refer to EC-108, "DTC Index".
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
TEST CONDITION:
Before performing the following procedure, confirm that battery voltage is more
than 9 V at idle
.
>> GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE
1. Start engine and let it idle for at least 5 seconds.
2. Check 1st trip DTC.
Is 1st trip DTC detected? YES >> Proceed to EC-288, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK DTC WITH ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)
With CONSULT-III
Check DTC with ABS actuator and electric unit (control unit). Refer to BRC-131, "CONSULT-III Function".
Is the inspection result normal? YES >> INSPECTION END
NO >> Perform Diagnosis Procedure corresponding to DTC indicated.
P0500 VSS
Description ECM receives vehicle speed signals from two different paths via CAN communication line: One is from the ABS actuator and electric unit (control unit) via the combination unit and the ...P0506 ISC system
Description The ECM controls the engine idle speed to a specified level through the fine adjustment of the air, which is let into the intake manifold, by operating the electric throttle control ac ...Other materials:
Body alignment
Body Center Marks (RHD Models)
A mark is placed on each part of the body to indicate the vehicle center.
When repairing the vehicle frame
(members, pillars, etc.) damaged by an accident which it enables more accurate
and effective repair by using
these marks together with body alignment speci ...
G sensor
Exploded View
1. Bracket
2. G sensor
: Vehicle front
: N·m (kg-m, ft-lb)
: N·m (kg-m, in-lb)
Removal and Installation
CAUTION:
• Never drop or strike G sensor, because it has little tolerance for impact.
• Never use a power tool to avoid impact.
REMOVAL
1. Disconnect the battery cable ...
Service regeneration
Description
Service Regeneration is performed with CONSULT-III to reduce particulate
matter in diesel particulate filter.
Service Regeneration should be performed in the following cases.
• ECM enters fail-safe mode because the amount of particulate matter in diesel
particulate filter reache ...