Nissan Juke Service and Repair Manual : P0488 EGR system

DTC Logic

DTC DETECTION LOGIC

Diagnosis Procedure


Diagnosis Procedure

1.CHECK EGR VOLUME CONTROL VALVE CONTROL CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect EGR volume control valve harness connector and ECM harness connector.

3. Check the continuity between EGR volume control valve terminal harness connector and ECM harness connector.

4. Also check harness for short to ground and short to power.


4. Also check harness for short to ground and short to power.

OK or NG OK >> GO TO 2.

NG >> Repair open circuit or short to ground or short to power in harness or connectors.

2.CHECK EGR VOLUME CONTROL VALVE

Refer to EC-954, "Component Inspection".

OK or NG OK >> GO TO 3.

NG >> Replace EGR volume control valve. Refer to EC-881, "Work Procedure".

3.CHECK EGR VOLUME CONTROL VALVE CONTROL POSITION SENSOR

Refer to EC-954, "Component Inspection".

OK or NG OK >> GO TO 4.

NG >> Replace EGR volume control valve. Refer to EC-881, "Work Procedure".

4.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> INSPECTION END

Component Inspection

EGR VOLUME CONTROL VALVE

1. Disconnect EGR volume control valve harness connector.

2. Check resistance EGR volume control valve harness connector.

If NG, replace EGR volume control valve. Refer to EC-881, "Work Procedure".


If NG, replace EGR volume control valve. Refer to EC-881, "Work Procedure".

EGR VOLUME CONTROL VALVE CONTROL POSITION SENSOR

1. Disconnect EGR volume control valve harness connector.

2. Check continuity EGR volume control valve harness connector.

If NG, replace EGR volume control valve. Refer to EC-881, "Work Procedure".


If NG, replace EGR volume control valve. Refer to EC-881, "Work Procedure".

    P0487 EGR volume control valve
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK EGR VOLUME CONTROL VALVE CONTROL CIRCUIT 1. Turn ignition switch OFF. 2. Disconnect EGR volume control valve harness connector and ECM ...

    P0504 ASCD brake SWI
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK GROUND CONNECTIONS 1. Turn ignition switch OFF and wait at least 20 seconds. 2. Check ground connection E38. Refer to Ground inspection ...

    Other materials:

    P1820 engine speed signal
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE With ...

    Blower fan resistor
    Exploded View 1. A/C unit assembly 2. Blower fan resistor*1 3. Sub harness*1 4. Power transistor*2 5. Sub harness*2 6. Blower motor • *1: Manual air conditioner • *2: Automatic air conditioner Removal and Installation REMOVAL 1. Remove instrument panel assembly. Refer to IP-13, &quo ...

    Precaution
    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver a ...