Nissan Juke Service and Repair Manual : Outside key antenna
Driver side
DRIVER SIDE : Removal and Installation
REMOVAL
Remove the driver side outside handle. Refer to DLK-176, "OUTSIDE HANDLE : Removal and Installation".
INSTALLATION
Install in the reverse order of removal.
Passenger side
PASSENGER SIDE : Removal and Installation
REMOVAL
Remove the passenger side outside handle. Refer to DLK-176, "OUTSIDE HANDLE : Removal and Installation".
INSTALLATION
Install in the reverse order of removal.
Rear bumper
REAR BUMPER : Removal and Installation
REMOVAL
1. Remove the rear bumper fascia. Refer to EXT-16, "Removal and Installation".
2. Remove the outside key antenna (rear bumper) (1) mounting clip (A), then remove outside key antenna (rear bumper).
INSTALLATION
Install in the reverse order of removal.
Inside key antenna
Instrument center INSTRUMENT CENTER : Removal and Installation REMOVAL 1. Remove the multi display unit. Refer to AV-125, "Removal and Installation". 2. Remove the inside key antenna ( ...Intelligent key warning buzzer
Removal and Installation REMOVAL 1. Remove the Intelligent Key warning buzzer (1) mounting bolt (A), and then remove the Intelligent Key warning buzzer. INSTALLATION Install in the reverse orde ...Other materials:
B1006, B1007, B1008, B1009, B1010 diagnosis sensor unit
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
driver and front passenger for certain
types of collision. Information necessary to service the system safely is
include ...
4WD warning lamp does not turn on
Description
4WD warning lamp does not turn ON when the ignition switch is turned to ON.
Diagnosis Procedure
1.CHECK 4WD WARNING LAMP
Perform the trouble diagnosis for 4WD warning lamp. Refer to DLN-80,
"Diagnosis Procedure".
Is the inspection result normal?
YES >> Check eac ...