Nissan Juke Service and Repair Manual : Operation inspection

Work Procedure

The purpose of the operational check is to check that the individual system operates normally.

Check condition : Engine running at normal operating temperature.

1.CHECK BLOWER MOTOR

1. Operate fan control dial.

2. Check that fan speed changes. Check operation for all fan speeds.

Is the inspection result normal? YES >> GO TO 2.

NO >> GO TO 8.

2.CHECK DISCHARGE AIR

1. Operate fan control dial to set the fan speed to maximum speed.

2. Operate MODE dial to each position.

3. Check that air outlets change according to each indicated air outlet by placing a hand in front of the air outlets. Refer to VTL-5, "System Description".

Is the inspection result normal? YES >> GO TO 3.

NO >> GO TO 8.

3.CHECK INTAKE AIR

1. Operate intake lever to each position.

2. Listen to intake sound and confirm air inlets change.

Is the inspection result normal? YES >> GO TO 4.

NO >> GO TO 8.

4.CHECK COMPRESSOR

1. Press A/C switch. The A/C switch indicator is turns ON.

2. Check visually and by sound that the compressor operates.

3. Press A/C switch again. The A/C switch indicator is turns OFF.

4. Check that compressor stops.

Is the inspection result normal? YES >> GO TO 5.

NO >> GO TO 8.

5.CHECK DISCHARGE AIR TEMPERATURE

1. Operate temperature control dial.

2. Check that discharge air temperature changes.

Is the inspection result normal? YES >> GO TO 6.

NO >> GO TO 8.

6.CHECK TEMPERATURE DECREASE

1. Operate compressor.

2. Turn temperature control dial to full cold position.

3. Check that cool air blows from the air outlets.

Is the inspection result normal? YES >> GO TO 7.

NO >> GO TO 8.

7.CHECK TEMPERATURE INCREASE

1. Turn temperature control dial to full hot position.

2. Check that warm air blows from air outlets.

Is the inspection result normal? YES >> INSPECTION END

NO >> GO TO 8.

8.CHECK SELF-DIAGNOSIS WITH CONSULT-III

1. Perform self-diagnosis with CONSULT-III.

2. Check that any DTC is detected.

Is any DTC detected? YES >> Perform trouble diagnosis for the detected DTC.

NO >> Refer to HAC-233, "Symptom Table" and perform the appropriate diagnosis.

    Diagnosis and repair workflow
    Work Flow OVERALL SEQUENCE DETAILED FLOW 1.INTERVIEW FOR MALFUNCTION Interview the symptom to the customer. >> GO TO 2. 2.SYMPTOM CHECK Check the symptom from the customer's informa ...

    Other materials:

    P1574 ASCD vehicle speed sensor
    Description The ECM receives two vehicle speed sensor signals via CAN communication line. One is sent from combination meter, and the other is from TCM (Transmission control module). The ECM uses these signals for ASCD control. Refer to EC-64, "AUTOMATIC SPEED CONTROL DEVICE (ASCD) : Sys ...

    Diagnosis system (BCM) (without intelligent key system)
    Common item : consult-III Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with BCM. SYSTEM APPLICATION BCM can perform the following functions for each system. NOTE: It can perform the diagnosis modes except the following for ...

    Door lock actuator
    Driver side DRIVER SIDE : Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “DOOR LOCK” in “ACTIVE TEST” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >& ...