Nissan Juke Service and Repair Manual : On Board Diagnosis (OBD) System of CVT and Engine

Nissan Juke Service and Repair Manual / Transaxle & transmissioN CVT: RE0F11A / Precaution / On Board Diagnosis (OBD) System of CVT and Engine

The ECM has an on board diagnostic system. It will light up the malfunction indicator lamp (MIL) to warn the driver of a malfunction causing emission deterioration.

CAUTION:
• Be sure to turn the ignition switch OFF and disconnect the battery cable from the negative terminal before any repair or inspection work. The open/short circuit of related switches, sensors, solenoid valves, etc. will cause the MIL to light up.

• Be sure to connect and lock the connectors securely after work. A loose (unlocked) connector will cause the MIL to light up due to an open circuit. (Be sure the connector is free from water, grease, dirt, bent terminals, etc.) • Be sure to route and secure the harnesses properly after work. Interference of the harness with a bracket, etc. may cause the MIL to light up due to a short circuit.

• Be sure to connect rubber tubes properly after work. A misconnected or disconnected rubber tube may cause the MIL to light up due to a malfunction of the EGR system or fuel injection system, etc.

• Be sure to erase the unnecessary malfunction information (repairs completed) from the TCM and ECM before returning the vehicle to the customer.

    General Precautions
    • Turn ignition switch OFF and disconnect the battery cable from the negative terminal before connecting or disconnecting the CVT assembly harness connector. Because battery voltage is applied to T ...

    Removal and Installation Procedure for CVT Unit Connector
    REMOVAL • Rotate bayonet ring (A) counterclockwise. Pull out CVT unit harness connector (B) upward and remove it. INSTALLATION 1. Align marking (A) on CVT unit harness connector terminal with m ...

    Other materials:

    Door switch
    Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “DOOR SW-DR”, “DOOR SW-AS”, “DOOR SW-RL”, “DOOR SW-RR”, “BACK DOOR SW” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the ...

    Key interlock cable
    Exploded View 1. CVT shift selector assembly 2. Key interlock cable A: Key cylinder B: Clip C: Clip Removal and Installation REMOVAL CAUTION: Always apply the parking brake before performing removal and installation. 1. Shift the selector lever to the “P” position. 2. Remove the sele ...

    Rear door lock
    Exploded View 1. Outside handle assembly 2. Rear door sealing screen 3. Door lock assembly 4. TORX bolt 5. Inside handle : Clip : Pawl : Vehicle front : Do not reuse : N·m (kg-m, in-lb) : Body grease Door lock DOOR LOCK : Removal and Installation REMOVAL 1. Remove rear door glass ...