Nissan Juke Service and Repair Manual : Oil pump
Exploded View
1. Oil pump drive chain
2. Crankshaft sprocket
3. Oil pump assembly
Removal and Installation
REMOVAL
1. Disconnect the battery cable from the negative terminal.
2. Remove engine under cover.
3. Remove front wheel RH. Refer to WT-7, "Exploded View".
4. Remove fender protector RH. Refer to EXT-22, "Exploded View".
5. Remove drive belt. Refer to EM-276, "Removal and Installation".
6. Remove oil pan. Refer to EM-288, "Exploded View".
7. Remove rear oil seal retainer. Refer to EM-302, "Exploded View".
8. Remove oil pump drive chain. Refer to EM-330, "Disassembly and Assembly".
9. Remove oil pump assembly.
INSTALLATION
Install in the reverse order of removal paying attention to the following.
Rear Oil Seal Retainer and Oil Pump • Refer to EM-330, "Disassembly and Assembly".
Oil cooler
Exploded View 1. Cylinder block 2. Water pipe 3. O-ring 4. O-ring 5. O-ring 6. Oil cooler 7. Connecting stud 8. O-ring 9. Oil filter bracket 10. Oil pressure switch 11. Oil filter ...Other materials:
B2619 BCM
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Press push-button ignition switch under the following conditions and wait
1 second or more.
- Selector lever: In the P position
- Brake pedal: Not depressed
2. Check DTC in “Self Diagnostic Re ...
Cylinder block
Disassembly and Assembly
PREPARING USED ENGINE
The engine should be cleaned and drained (oil and water).
Leave on the used engine or include in the return box:
• Oil filter
• Oil pressure switch
• Water pump
• Fuel injection pump
• Rail
• Injectors
• Glow plugs
• Oil level gauge
• Vacu ...
Normal operating condition
Description
FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED)
If the engine speed is above 2,400 rpm under no load (for example, the shift
lever position is neutral and
engine speed is over 2,400 rpm) fuel will be cut off after some time. The exact
time when the fuel is cut off varies
base ...