Nissan Juke Service and Repair Manual : Oil filter
Exploded View
1. O-ring
2. Oil filter bracket
3. Oil pressure switch
4. Oil filter
5. O-ring
6. Connecting bolt
A. To oil cooler
: N·m (kg-m, ft-lb)
: Always replace after every
disassembly.
Removal and Installation
REMOVAL
1. Using an oil filter wrench [SST:KV113C0010 (Mot.1329)] (A) remove oil filter.
CAUTION:
• Be careful not to get burned when the engine and engine oil
are hot.
• When removing, prepare a shop cloth to absorb any oil leakage or spillage.
• Never allow engine oil to adhere to the drive belts.
• Completely wipe off any oil that adhere to the engine and the vehicle.
INSTALLATION
1. Remove foreign materials adhering to the oil filter installation surface.
2. Install oil filter bracket to oil cooler.
CAUTION:
Install oil filter bracket, positioning lug in the hole of oil cooler.
3. Apply engine oil to the oil seal contact surface of the new oil filter.
4. Install the oil filter until it comes into contact with the oil seal on the engine bracket.
5. Tighten the oil filter three-quarters of a turn by hand.
6. After warming up the engine, check for engine oil leakage.
7. Check oil level and add engine oil. Refer to LU-33.
Engine oil
Inspection OIL LEVEL AND MUDDINESS • Before starting the engine, check the oil level placing vehicle horizontally. If the engine is already started, stop it and allow 10 minutes before checkin ...Other materials:
Brake master cyl
Exploded View
2WD
1. Reservoir cap
2. Oil strainer
3. Reservoir tank
4. Cylinder body
5. Pin
6. O-ring
7. Grommet
: Apply polyglycol ether based
lubricant.
: Apply brake fluid.
: N·m (kg-m, ft-lb)
: Always replace after every
disassembly.
4WD
1. Reservoir cap
2. Oil strai ...
Diagnosis system (air bag)
Description
CAUTION:
• Never use electrical test equipment on any circuit related to the SRS unless
instructed in this Service
Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses
or harness
connectors.
• Never repair, splice or modify the SRS wiring harness. If ...
On board diagnostic (OBD) system
Diagnosis Description
This system is an on board diagnostic system that records exhaust
emission-related diagnostic information
and detects a sensors/actuator-related malfunction. A malfunction is indicated
by the malfunction indicator
lamp (MIL) and stored in ECU memory as a DTC. The diagnos ...