Nissan Juke Service and Repair Manual : Oil filter

Removal and Installation

REMOVAL

1. Remove engine under cover.

2. Using oil filter wrench [SST: KV10115801 (J-38956)] (A), remove oil filter.

CAUTION:: Vehicle front


CAUTION:
• Oil filter is provided with relief valve. Use genuine NISSAN oil filter or equivalent.

• Be careful not to get burned when engine and engine oil may be hot.

• When removing, prepare a shop cloth to absorb any engine oil leakage or spillage.

• Completely wipe off any engine oil that adheres to engine and vehicle.

INSTALLATION


INSTALLATION

1. Remove foreign materials adhering to the oil filter installation surface.

2. Apply new engine oil to the oil seal contact surface of new oil filter.

3. Screw oil filter manually until it touches the installation surface,


3. Screw oil filter manually until it touches the installation surface, then tighten it by 2/3 turn (A). Or tighten to specification.

Oil filter:
: 17.7 N·m (1.8 kg-m, 13 ft-lb)


Inspection


Inspection

INSPECTION AFTER INSTALLATION

1. Check the engine oil level. Refer to LU-8, "Inspection".

2. Start the engine, and check that there is no leakage of engine oil.

3. Stop the engine and wait for 10 minutes.

4. Check the engine oil level, and adjust the level. Refer to LU-8, "Inspection".

    Engine oil
    Inspection ENGINE OIL LEVEL NOTE: Before starting engine, put vehicle horizontally and check the engine oil level. If engine is already started, stop it and allow 10 minutes before checking. ...

    Removal and installation
    OIL COOLER ...

    Other materials:

    C1607, C1608 EPS control unit
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE With ...

    B1120 satellite sensor LH
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.CHECK SELF-DIAG RESULT With CONSULT-III 1. Turn ignition switch ON. 2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III. Without CONSULT-III 1. Turn ignition switch ON. 2. Check the air bag warning lamp statu ...

    Side oil seal
    Removal and Installation REMOVAL 1. Remove front drive shafts. (MR16DDT) Refer to FAX-22, "LEFT SIDE : Removal and Installation" (LEFT SIDE) and FAX-24, "RIGHT SIDE : Removal and Installation" (RIGHT SIDE). 2. Remove front drive shafts. (K9K) Refer to FAX-78, "LEFT SID ...