Nissan Juke Service and Repair Manual : Oil cooler

Exploded View

1. Cylinder block


1. Cylinder block
2. Water pipe
3. O-ring
4. O-ring
5. O-ring
6. Oil cooler
7. Connecting stud
8. O-ring
9. Oil filter bracket
10. Oil pressure switch 11. Oil filter
12. O-ring
13. Connecting bolt

A. : To radiator lower hose B. : To water pump

: Always replace after every: N·m (kg-m, ft-lb)
disassembly.: Always replace after every
disassembly.

CAUTION:
• Be careful not to get burned when the engine and engine oil are hot.

• When removing, prepare a shop cloth to absorb any oil leakage or spillage.

• Completely wipe off any oil that abhere to the engine and the vehicle.

Removal and Installation

REMOVAL

1. Drain engine coolant. Refer to CO-62, "Draining".

CAUTION:
Perform when engine is cold.

2. Remove oil filter and oil filter bracket. Refer to LU-35, "Exploded View".

3. Remove alternator.

4. Remove oil cooler.

INSTALLATION

Installation is in reverse order of removal.

• Replace the O-ring (A) of the oil cooler, positioning the lip (B) of the seal behind the lug (C) of the oil cooler.

• Confirm that no foreign objects are adhering to the installation planes of


• Confirm that no foreign objects are adhering to the installation planes of the oil cooler and block.

Inspection

Oil Cooler
Check oil cooler for cracks and clogging by blowing through coolant inlet. If necessary, replace oil cooler assembly.

    Oil pump
    Exploded View 1. Oil pump drive chain 2. Crankshaft sprocket 3. Oil pump assembly Removal and Installation REMOVAL 1. Disconnect the battery cable from the negative terminal. 2. Remove eng ...

    Service data and specifications (SDS)
    Standard and Limit OIL PRESSURE OIL CAPACITY (APPROXIMATE) TIGHTENING TORQUE ...

    Other materials:

    Wiring diagram
    BCM LHD LHD : Wiring Diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Connector Information/Explanation of Option Abbreviation". RHD RHD : Wiring Diagram For con ...

    Precautions on cruise control
    •  If the cruise control system malfunctions, it will cancel automatically. The CRUISE indicator light on the meter panel will then blink to warn the driver. •  If the engine coolant temperature becomes excessively high, the cruise control system will cancel automatically. •  If ...

    Output speed sensor
    Exploded View 1. Transaxle assembly 2. Output speed sensor 3. O-ring : Vehicle front : Always replace after every disassembly. : N·m (kg-m, in-lb) : Genuine NISSAN CVT Fluid NS-2 Removal and Installation REMOVAL 1. Disconnect battery cable from negative terminal. Refer to PG-124, &qu ...