Nissan Juke Owners Manual : Non-adjustable head restraint/headrest components
1. Removable head restraint/headrest
2. Single notch
3. Lock knob
4. Stalks
Adjustable head restraint/headrest components
1. Removable head restraint/headrest 2. Multiple notches 3. Lock knob 4. Stalks ...Remove
Use the following procedure to remove the head restraint/headrest. 1. Pull the head restraint/headrest up to the highest position. 2. Push and hold the lock knob. 3. Remove the head restraint/hea ...Other materials:
Positive crankcase ventilation
Inspection
1.CHECK PCV VALVE
With engine running at idle, remove PCV valve from rocker cover. A
properly working valve makes a hissing noise as air passes through
it. A strong vacuum should be felt immediately when a finger is
placed over valve inlet.
Is the inspection result normal?
YES &g ...
B2013 steering lock unit
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Lock the steering.
NOTE:
3. Press the push-button ignition switch.
4. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III.
Is DTC detected?
YES >> Go to SEC-69, & ...
Precaution
Precautions for Suspension
• When installing rubber bushings, the final tightening must be carried out
under unladen conditions with tires
on ground. Spilled oil might shorten the life of rubber bushings. Be sure to
wipe off any spilled oil.
- Unladen conditions mean that fuel, engine coolant ...