Nissan Juke Service and Repair Manual : MR16DDT : Removal and Installation

REMOVAL

1. Disconnect the battery cable from the negative terminal. Refer to PG-124, "Removal and Installation".

2. Drain engine coolant from radiator. Refer to CO-11, "Draining".

3. Remove charge air cooler. Refer to EM-31, "Removal and Installation".

4. Remove CVT water hose A on thermostat housing side (CVT models). Refer to CO-17, "Exploded View".

5. Remove radiator hose (lower) on thermostat housing side. Refer to CO-17, "Removal and Installation".

6. Move CVT water hose A and radiator hose (lower) to a location where they do not inhibit work.

7. Open “B” terminal cover, in the direction indicated by an arrow, as shown in the figure.

8. Remove “B” terminal nut and “B” terminal harness.


8. Remove “B” terminal nut and “B” terminal harness.

9. Remove “S” terminal nut and “S” terminal harness.

10. Disconnect harness connector (1) from crankshaft position sensor.

11. Remove harness fixing clip (A) from oil pan (upper), and then move harness (2) to a location where they do not inhibit work.

12. Remove starter motor mounting bolts.


12. Remove starter motor mounting bolts.

13. Remove starter motor forward from the vehicle.

INSTALLATION

Note the following items, and install in the reverse order of removal.

CAUTION:
• Be careful to tighten “B” terminal nut to the specified torque.

• After work is complete fill engine coolant. Refer to CO-12, "Refilling".

    MR16DDT : Exploded View
    REMOVAL 1. “S” terminal harness 2. “B” terminal harness 3. Starter motor 4. Cylinder block : Vehicle front : N·m (kg-m, in-lb) : N·m (kg-m, ft-lb) DISASSEMBLY Type: S114-902 1. Magneti ...

    MR16DDT : Inspection and Adjustment
    INSPECTION Magnetic Switch Check • Before starting to check, disconnect the battery cable from the negative terminal. • Disconnect “M” terminal of starter motor. 1. Continuity test [between “S ...

    Other materials:

    C1115 wheel sensor
    DTC Logic DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CONSULT-III. 1. Stat the en ...

    Diagnosis and repair work flow
    WorkFlow DETAILED FLOW 1.OBTAIN INFORMATION ABOUT SYMPTOM Interview the customer to obtain the malfunction information (conditions and environment when the malfunction occurred) as much as possible when the customer brings the vehicle in. >> GO TO 2. 2.REPRODUCE THE MALFUNCTION INF ...

    Drive belt
    Checking Drive Belts WARNING: Be sure to perform when the engine is stopped. 1. Inspect belts for cracks, fraying, wear and oil. If necessary, replace. 2. Evaluate manually if the belt is enough tensioned (tension cannot be measured by way of frequency meter). CAUTION: Auto-tensioner must ...