Nissan Juke Service and Repair Manual : Mixture ratio self-learning value clear

Description

This describes how to erase the mixture ratio self-learning value. For the actual procedure, follow the instructions in “Diagnosis Procedure”.

Work Procedure

1. Start engine and warm it up to normal operating temperature.With CONSULT-III


1. Start engine and warm it up to normal operating temperature.

2. Select “SELF-LEARNING CONT” in “WORK SUPPORT” mode of “ENGINE” using CONSULT-III.

3. Clear mixture ratio self-learning value by touching “CLEAR”.

1. Start engine and warm it up to normal operating temperature. With GST


1. Start engine and warm it up to normal operating temperature.

2. Turn ignition switch OFF.

3. Disconnect mass air flow sensor harness connector.

4. Restart engine and let it idle for at least 5 seconds.

5. Stop engine and reconnect mass air flow sensor harness connector.

6. Select Service $03 with GST. Make sure DTC P0102 is detected.

7. Select Service $04 with GST to erase the DTC P0102.

>> END

    G sensor calibration
    Description ECM stores calibration data (inherent characteristic value) of G sensor to provide accurate control. Therefore, it is required to perform calibration of G sensor after the following wo ...

    Fuel pressure
    Work Procedure FUEL PRESSURE RELEASE With CONSULT-III 1. Turn ignition switch ON. 2. Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode of “ENGINE” using CONSULT-III. 3. Start engine. 4. ...

    Other materials:

    Break-in schedule
    CAUTION During the first 1,200 miles (2,000 km), follow these recommendations to obtain maximum engine performance and ensure the future reliability and economy of your new vehicle. Failure to follow these recommendations may result in shortened engine life and reduced engine performance. •& ...

    Power supply and ground circuit
    Diagnosis Procedure 1.CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) IGNITION POWER SUPPLY 1. Turn the ignition switch OFF. 2. Disconnect ABS actuator and electric unit (control unit) harness connector. 3. Check voltage between ABS actuator and electric unit (control unit) harness conne ...

    Both side headlamps (LO) are not turned on
    Description Both side headlamps (LO) are not turned ON in any condition. Diagnosis Procedure 1.CHECK COMBINATION SWITCH Check the combination switch. Refer to BCS-92, "Symptom Table". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace the malfun ...