Nissan Juke Service and Repair Manual : Microphone
Removal and Installation
REMOVAL
1. Remove headlining. Refer to INT-26, "Exploded View".
2. Remove microphone connector and pawl to remove microphone.
INSTALLATION
Install in the reverse order of removal.
GPS antenna
Feeder Layout Removal and Installation REMOVAL 1. Remove instrument panel. Refer to IP-12, "Exploded View". 2. Remove antenna feeder clip, then remove GPS antenna screw and remove GPS ...Steering switch
Exploded View Refer to SR-13, "Exploded View". Removal and Installation REMOVAL Refer to SR-13, "Removal and Installation". INSTALLATION Install in the reverse order of rem ...Other materials:
P2122, P2123 APP sensor
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P2122 or P2123 is displayed with DTC P0643, first perform the trouble
diagnosis for DTC P0643.
Refer to EC-686, "DTC Logic".
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, alw ...
System
System Description
SYSTEM DIAGRAM
• The multi display unit transmits the operation status of the drive mode
switch to other units via CAN communication
as the mode signal (refer below).
- NORMAL: ON/OFF
- SPORT: ON/OFF
- ECO: ON/OFF
• Based on the mode signals received from TCM (CVT mod ...
P1610 lock mode
Description
ECM forcibly switches to the mode that inhibits engine start, when engine
start operation is performed 5 times
or more while communication between ECM and BCM is not normal, or when engine
start operation is performed
5 times or more using the unregistered ignition key.
DTC Logic ...