Nissan Juke Owners Manual : Map light control switch (if so equipped)
The map lights control switch has three positions: ON1 , OFF2 and center.
ON position
When the switch is in the ON position 1 , the map lights will illuminate.
OFF position
When the switch is in the OFF position2 , the map lights will not illuminate, regardless of the condition.
Center position
When the switch is in the center position, the map lights will illuminate under the following conditions:
• ignition switch is placed in the OFF position (models with Intelligent
Key system)
— remain on for about 15 seconds.
• the key is removed from the ignition switch (models without Intelligent Key system) — remain on for about 15 seconds.
• doors are unlocked by pushing the UNLOCK button (on the keyfob or Intelligent Key) or the request switch (Intelligent Key system equipped model), with the ignition switch in the LOCK position — remain on for about 15 seconds.
• any door is opened and then closed with the ignition switch in the LOCK
position
— remain on for about 15 seconds.
• any door is opened with the ignition switch in the ACC or ON position — remain on while the door is opened.
When the door is closed, the lights go off.
The lights will turn off after a period of time when the lights remain illuminated to prevent the battery from becoming discharged.
Map lights (if so equipped)
Operate the map light switch to turn the map light on or off. 1 : ON position 2 : OFF position ...Cargo light
The cargo room lights illuminate when the lift gate is opened. When the lift gate is closed, the lights will turn off. ...Other materials:
P0300, P0301, P0302, P0303, P0304 misfire
DTC Logic
DTC DETECTION LOGIC
When a misfire occurs, engine speed will fluctuate. If the engine speed
fluctuates enough to cause the crankshaft
position (CKP) sensor (POS) signal to vary, ECM can determine that a misfire is
occurring.
The misfire detection logic consists of the following t ...
B263D, B263E, B263F intake door motor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT-III
1. Turn ignition switch ON.
2. Select “Self Diagnostic Result” mode of “HVAC” using CONSULT-III.
3. Check DTC.
Is DTC detected?
YES >> Refer to HAC-159, "Diagnosis P ...
Back door lock
Exploded View
1. Back door lock assembly
2. TORX bolt
3. Back door striker
: Do not reuse
: N·m (kg-m, ft-lb)
: Body grease
Door lock
DOOR LOCK : Removal and Installation
REMOVAL
1. Remove the back door lower finisher. Refer to INT-35, "BACK DOOR LOWER
FINISHER : Removal and
In ...