Nissan Juke Service and Repair Manual : Map lamp
Exploded View
1. Map lamp bulb housing
2. Bulb
3. Lens
: Pawl
Removal and Installation
CAUTION:
Disconnect the battery negative terminal or the fuse.
REMOVAL
1. Remove the lens (1).
• Insert a remover tool (A) into the gap between the lens.
• Disengage the lens fixing pawls, and then remove the lens.
CAUTION:
Use a remover tool wrapped in tape.
2. Press pawl in the direction shown by the arrow in the figure using a remover tool (A), and then pull the map lamp housing (1) in the direction shown by the arrow in the figure.
CAUTION:
Use a remover tool wrapped in tape.
3. Disconnect map lamp harness connector, and then remove map lamp housing.
INSTALLATION
Install in the reverse order of removal.
Replacement
CAUTION:
• Disconnect battery negative terminal or the fuse.
• Never touch glass of bulb directly by hand. Keep grease and other oily matters away from it.
• Never touch bulb by hand while it is lit or right after being turned off.
• Never leave bulb out of lamp reflector for a long time because dust, moisture smoke, etc. may affect the performance of lamp. When replacing bulb, be sure to replace it with new one.
MAP LAMP BULB
1. Remove the lens (1).
• Insert a remover tool (A) into the gap between the lens.
• Disengage the lens fixing pawls, and then remove the lens.
: Pawl
CAUTION:
Use a remover tool wrapped in tape.
2. Remove the bulb.
Luggage room lamp
Exploded View 1. Bulb housing 2. Bulb 3. Lens : Pawl Removal and Installation CAUTION: Disconnect the battery cable from negative terminal or remove the fuse. REMOVAL 1. Insert a remover ...Other materials:
Off position warning does not operate
Diagnosis Procedure
1.CHECK DTC WITH BCM AND COMBINATION METER
Check that DTC is not detected with BCM and combination meter.
Is the inspection result normal?
YES >> GO TO 2.
NO-1 >> Refer to BCS-67, "DTC Index". (BCM)
NO-2 >> Refer to MWI-36, "DTC Index&qu ...
Compression pressure
Inspection
1. Warm up engine thoroughly. Then, stop it.
2. Release fuel pressure. Refer to EC-551, "Work Procedure".
3. Remove ignition coil and spark plug from each cylinder. Refer to EM-178,
"Exploded View".
4. Connect engine tachometer (not required in use of CONSULT-III ...
HR16DE : Exploded View
REMOVAL
1. Cylinder block
2. “B” terminal harness
3. “S” terminal harness
4. Starter motor
: Vehicle front
: N·m (kg-m, in-lb)
: N·m (kg-m, ft-lb)
DISASSEMBLY
Type: M000T32172ZE
1. “M” terminal nut
2. Magnetic switch assembly
3. Adjusting plate
4. Metal FR
5. Gear case
6. Yo ...