Nissan Juke Service and Repair Manual : Magnet clutch

Component Function Check

1.CHECK MAGNET CLUTCH OPERATION

Perform auto active test of IPDM E/R. Refer to PCS-12, "Diagnosis Description" (with Intelligent Key) or PCS- 43, "Diagnosis Description" (without Intelligent Key).

Does it operate normally? YES >> INSPECTION END

NO >> Refer to HAC-293, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK FUSE

1. Turn ignition switch OFF.

2. Check 10A fuse (No. 49, located in IPDM E/R).

NOTE

:
Refer to PG-25, "Fuse, Connector and Terminal Arrangement".

Is the inspection result normal? YES >> GO TO 2.

NO >> Replace the blown fuse after repairing the affected circuit if a fuse is blown.

2.CHECK MAGNET CLUTCH

1. Disconnect compressor connector.

2. Directly apply battery voltage to the magnet clutch. Check for operation visually and by sound.

Does it operate normally? YES >> GO TO 3.

NO-1 >> HR16DE: Replace magnet clutch. Refer to HA-32, "MAGNET CLUTCH : Removal and Installation of Compressor Clutch".

NO-2 >> MR16DDT: Replace magnet clutch. Refer to HA-88, "MAGNET CLUTCH : Removal and Installation of Compressor Clutch".

3.CHECK MAGNET CLUTCH POWER SUPPLY CIRCUIT FOR OPEN

1. Disconnect IPDM E/R connector.

2. Check continuity between IPDM E/R harness connector and compressor harness connector.

Is the inspection result normal?


Is the inspection result normal? YES >> Replace IPDM E/R. Refer to PCS-34, "Removal and Installation" (with Intelligent Key) or PCS-63, "Removal and Installation" (without Intelligent Key).

NO >> Repair harness or connector.

    Blower motor
    Diagnosis Procedure 1.CHECK SYMPTOM Check symptom (A or B). Which symptom is detected? A >> GO TO 2. B >> GO TO 7. 2.CHECK FUSE 1. Turn ignition switch OFF. 2. Check 15A fuse ...

    PTC heater
    Component Function Check 1.CHECK PTC HEATER OPERATION 1. Start the engine. 2. Operate fan control dial. 3. Operate temperature control dial to full hot position. 4. Check for warm air at discharg ...

    Other materials:

    Key reminder function does not operate
    Diagnosis Procedure 1.CHECK DTC WITH BCM Check that DTC is not detected with BCM. Is the inspection result normal? YES >> GO TO 2. NO >> Refer to BCS-67, "DTC Index". 2.CHECK “ANTI KEY LOCK IN FUNCTI” SETTING IN “WORK SUPPORT” 1. Select “INTELLIGENT KEY” of “BCM” u ...

    Main line betweeN DLC and MDU circuit
    Diagnosis Procedure 1.CHECK HARNESS CONTINUITY (OPEN CIRCUIT) 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect the following harness connectors. - ECM - Multi display unit 4. Check the continuity between the data link connector and the ...

    Low pressure fuel pump
    M/T models : Component Function Check 1.CHECK FUEL PUMP FUNCTION 1. Turn ignition switch ON. 2. Pinch fuel feed hose with two fingers. NOTE: Fuel pressure pulsation should be felt on the fuel feed hose for 1 second after ignition switch is turned ON. Is the inspection result normal? YES ...