Nissan Juke Service and Repair Manual : Liquid Gasket

REMOVAL OF LIQUID GASKET SEALING

• After removing mounting nuts and bolts, separate the mating surface using the seal cutter [SST: KV10111100] (A) and remove old liquid gasket sealing.

CAUTION:
Be careful not to damage the mating surfaces.

• Tap the seal cutter [SST: KV10111100] to insert it (B), and then slide it (C) by tapping on the side as shown in the figure.

• In areas where the seal cutter [SST: KV10111100] is difficult to use, lightly tap the parts using a plastic hammer to remove it.

CAUTION:
If for some unavoidable reason tool such as a screwdriver is used, be careful not to damage the mating surfaces.

LIQUID GASKET APPLICATION PROCEDURE


LIQUID GASKET APPLICATION PROCEDURE

1. Using a scraper (A), remove old liquid gasket adhering to the liquid gasket application surface and the mating surface.

• Remove liquid gasket completely from the groove of the liquid gasket application surface, mounting bolts, and bolt holes.

2. Wipe the liquid gasket application surface and the mating surface with white gasoline (lighting and heating use) to remove adhering moisture, grease and foreign materials.

3. Attach liquid gasket tube to the tube presser (commercial service


3. Attach liquid gasket tube to the tube presser (commercial service tool).

Use Genuine Liquid Gasket or equivalent.

4. Apply liquid gasket without gaps to the specified location according to the specified dimensions.

• If there is a groove for liquid gasket application, apply liquid gasket to the groove.

• As for bolt holes (B), normally apply liquid gasket inside the


• As for bolt holes (B), normally apply liquid gasket inside the holes. Occasionally, it should be applied outside the holes.

Check to read the text of this manual.

A : Groove
: Inside


• Within five minutes of liquid gasket application, install the mating


• Within five minutes of liquid gasket application, install the mating component.

• If liquid gasket protrudes, wipe it off immediately.

• Do not retighten mounting bolts or nuts after the installation.

• After 30 minutes or more have passed from the installation, fill engine oil and engine coolant.

CAUTION:
If there are specific instructions in this manual, observe them

.

    Parts Requiring Angle Tightening
    • Use the angle wrench [SST: KV10112100] for the final tightening of the following engine parts: - Camshaft sprocket (INT) bolt - Cylinder head bolts - Main bearing cap bolts - Connecting rod ca ...

    Other materials:

    Insufficient heating
    Description Symptom • Insufficient heating • No warm air comes out. (Air flow volume is normal.) Diagnosis Procedure NOTE: Perform self-diagnosis with CONSULT-III before performing symptom diagnosis. If any malfunction result or DTC is detected, perform the corresponding diagnosis. 1.CHE ...

    B2268 water temp
    Description The engine coolant temperature signal is transmitted from ECM to the combination meter via CAN communication. DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.PERFORM SELF-DIAGNOSIS OF ECM Perform “Self Diagnosis Result” of “ENGINE”, and repair or replace malfunctioning pa ...

    Engine does not start or starts with difficulty
    Description CHART 2: ENGINE DOES NOT START OR STARTS WITH DIFFICULTY Diagnosis Procedure 1.CHECK FUEL Check that the fuel reservoir is correctly filled and with the right fuel. >> GO TO 2. 2.CHECK BATTERY Check the battery. Refer to PG-124, "Removal and Installation". I ...