Nissan Juke Service and Repair Manual : Lighting & turn signal switch
Removal and Installation
REMOVAL
Remove light & turn signal switch. Refer to BCS-94, "Removal and Installation".
INSTALLATION
Install in the reverse order of removal.
Light & rain sensor
Exploded View CAUTION: When the light & rain sensor is removed from windshield, the light & rain sensor cannot be re-used. REMOVAL 1. Light & rain sensor bracket 2. Mirror base ...Hazard switch
Exploded View 1. Instrument panel assembly 2. Hazard switch : Pawl Removal and Installation REMOVAL 1. Remove Audio unit. Refer to AV-38, "Removal and Installation". 2. Disengage f ...Other materials:
ASCD steering switch
Component Function Check
1.CHECK ASCD STEERING SWITCH FUNCTION
1. Turn ignition switch ON.
2. Check the voltage between ECM harness connector terminals under the following
conditions.
Is the inspection result normal?
YES >> INSPECTION END
NO >> Go to EC-1011, "Diagnosis Pr ...
Diagnosis system (BCM) (without intelligent key system)
Common item
COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM)
APPLICATION ITEM
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the ...
B2562 low voltage
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.DTC CONFIRMATION
1. Erase DTC.
2. Turn ignition switch OFF.
3. Perform the “Self Diagnostic Result” of BCM with CONSULT-III, when passed 120
seconds or more after
the ignition switch is turned ON.
Is any DTC detected?
YES > ...