Nissan Juke Service and Repair Manual : Light & rain sensor

Exploded View

1. Light & rain sensor bracket


1. Light & rain sensor bracket 2. Mirror base
3. Light & rain sensor 4. Inside mirror assembly

: Do not reuse: Pawl
Removal and Installation: Do not reuse


Removal and Installation

CAUTION:
When the light & rain sensor is removed from windshield, the light & rain sensor cannot be reused.

REMOVAL

1. Remove inside mirror assembly. Refer to MIR-41, "Removal and Installation".

2. Disconnect light & rain sensor connector.

3. Disengage both sides fixing pawls, and remove the light & rain sensor from the windshield.

INSTALLATION

Note the following items, and then install in the reverse order of removal.

CAUTION:
• Surface of windshield should be cleaned.

• Never touch gel/adhesive of new part.

    Front wiper drive assembly
    Exploded View REMOVAL LHD models 1. Front wiper arm cap 2. Front wiper arm LH 3. Front wiper blade LH 4. Front wiper arm RH 5. Front wiper blade RH 6. Front wiper drive assembly : Pawl ...

    Wiper and washer switch
    Exploded View The washer level switch must be replaced together with the washer tank as an assembly. Refer to WW-67, "Removal and Installation". ...

    Other materials:

    Super lock actuator
    Driver side DRIVER SIDE : Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “SUPER LOCK” in “ACTIVE TEST” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES > ...

    Clutch disc and clutch cover
    Except for K9K : Exploded View HR16DE 1. Flywheel 2. Clutch disc 3. Clutch cover 4. Input shaft A. First step B. Final step : N·m (kg-m, ft-lb) : Apply lithium-based grease including molybdenum disulphide. MR16DDT 1. Flywheel 2. Clutch disc 3. Clutch cover 4. Input shaft A. ...

    P0520 EOP sensor
    DTC Logic DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. Turn ignition switch ON. 3. Turn ignitio ...