Combination switch

Exploded View 1. Combination switch 2. Combination switch connector Removal and Installation REMOVAL 1. Remove steering column cover. Refer to IP-13, "Removal and Installation". 2 ...

Precaution

Precautions for Trouble Diagnosis CAUTION: • Never apply 7.0 V or more to the measurement terminal. • Use a tester with open terminal voltage of 7.0 V or less. • Turn the ignition switch OFF and d ...

Other materials:

Diagnosis and repair workflow
Work Flow OVERALL SEQUENCE DETAILED FLOW 1.INTERVIEW FOR MALFUNCTION Interview the symptom to the customer. >> GO TO 2. 2.SYMPTOM CHECK Check the symptom from the customer's information. >> GO TO 3. 3.BASIC INSPECTION Check the operation of each part. Check that any s ...

Rear stabilizer
Exploded View 1. Stabilizer bar 2. Bushing 3. Stabilizer clamp 4. Stabilizer link 5. Lower link 6. Rear suspension member : Vehicle front : Always replace after every disassembly. : N·m (kg-m, ft-lb) Removal and Installation REMOVAL 1. Remove stabilizer link. 2. Remove center pi ...

C1606 EPS motor
DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE With ...