Nissan Juke Service and Repair Manual : Keyfob ID registration
Description
Perform the following procedure after BCM is replaced or when new keyfob ID is registered NOTE
:
When registering the keyfob ID, perform only one procedure to simultaneously
register both ID (IMMOBILIZER
ID and keyfob ID).
Work Procedure
1.STEP 1
Close all doors.
>> GO TO 2.
2.STEP 2
Operate lock using the driver side door lock and unlock switch.
>> GO TO 3.
3.STEP 3
1. Remove and insert the key into the ignition key 6 times within 10seconds (turning the key switch from OFF to ON counts as 1 time).
2. Hazard warning lamp blinks(2 times).
NOTE
:
On the sixth key insertion, keep the key in the cylinder with the key switch ON.
Does the hazard lamp blink? YES >> GO TO 4.
NO >> GO TO 1.
4.STEP 4
Within 3 seconds after the hazard lamp blinks, turn ignition switch to the ACC position and operate lock using the driver side door lock and unlock switch.
>> GO TO 5.
5.STEP 5
1. Press the lock or unlock button of the keyfob to be added.
2. All doors unlock simultaneously.
3. Hazard warning lamp blinks(2 times).
4. Key ID is registered.
Is key ID registered? YES-1 >> When adding a keyfob: GO TO 6.
YES-2 >> When ending registration: GO TO 8.
NO >> GO TO 1.
6.STEP 6
Operate lock using the driver side door lock and unlock switch.
>> GO TO 7.
7.STEP 7
1. Press the lock or unlock button of the keyfob to be added.
2. All doors unlock simultaneously.
3. Hazard warning lamp blinks(2 times).
4. Key ID is registered.
Is key ID registered? YES-1 >> When adding a keyfob: GO TO 6.
YES-2 >> When ending registration: GO TO 8.
NO >> GO TO 6.
8.STEP 8
Open the front door driver side.
>> REGISTRATION END
Diagnosis and repair work flow
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
1.GET INFORMATION FOR SYMPTOM
1. Get the detailed information from the customer about the symptom (the
condition and the environment
when the incident ...
Other materials:
P range interlock door lock/unlock function does not operate
Diagnosis Procedure
1.CHECK “AUTOMATIC LOCK/UNLOCK SELECT” SETTING IN “WORK SUPPORT”
1. Select “DOOR LOCK” of “BCM” using CONSULT-III.
2. Select “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT” mode.
3. Check “AUTOMATIC LOCK/UNLOCK SELECT” in “WORK SUPPORT”.
Refer to DLK-217, "DOOR LOCK ...
P1556, P1557 battery temperature
sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
1. Turn ignition switch OFF and wait at lest 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm ...
Rear window defogger relay
Description
The rear window defogger is operated by turning the rear window defogger
switch ON.
Component Function Check
1.CHECK FUNCTION
1. Perform IPDM E/R Active Test (“REAR DEFOGGER”) using CONSULT-III.
2. Touch “ON”.
3. Check that the rear window heating wire is getting warmer.
Is th ...
