Nissan Juke Service and Repair Manual : Keyfob id registration
Description
Perform the following procedure after BCM is replaced or when new keyfob ID is registered NOTE
:
When registering the keyfob ID, perform only one procedure to simultaneously
register both ID (IMMOBILIZER
ID and keyfob ID).
Work Procedure
1.STEP 1
Close all doors.
>> GO TO 2.
2.STEP 2
Operate lock using the driver side door lock and unlock switch.
>> GO TO 3.
3.STEP 3
1. Remove and insert the key into the ignition key 6 times within 10seconds (turning the key switch from OFF to ON counts as 1 time).
2. Hazard warning lamp blinks(2 times).
NOTE
:
On the sixth key insertion, keep the key in the cylinder with the key switch ON.
Does the hazard lamp blink? YES >> GO TO 4.
NO >> GO TO 1.
4.STEP 4
Within 3 seconds after the hazard lamp blinks, turn ignition switch to the ACC position and operate lock using the driver side door lock and unlock switch.
>> GO TO 5.
5.STEP 5
1. Press the lock or unlock button of the keyfob to be added.
2. All doors unlock simultaneously.
3. Hazard warning lamp blinks(2 times).
4. Key ID is registered.
Is key ID registered? YES-1 >> When adding a keyfob: GO TO 6.
YES-2 >> When ending registration: GO TO 8.
NO >> GO TO 1.
6.STEP 6
Operate lock using the driver side door lock and unlock switch.
>> GO TO 7.
7.STEP 7
1. Press the lock or unlock button of the keyfob to be added.
2. All doors unlock simultaneously.
3. Hazard warning lamp blinks(2 times).
4. Key ID is registered.
Is key ID registered? YES-1 >> When adding a keyfob: GO TO 6.
YES-2 >> When ending registration: GO TO 8.
NO >> GO TO 6.
8.STEP 8
Open the front door driver side.
>> REGISTRATION END
Diagnosis and repair work flow
Work Flow OVERALL SEQUENCE DETAILED FLOW 1.GET INFORMATION FOR SYMPTOM 1. Get the detailed information from the customer about the symptom (the condition and the environment when the incident ...Other materials:
Tow Truck Towing
CAUTION:
• All applicable state or Provincial laws and local laws regarding the towing
operation must be
obeyed.
• It is necessary to use proper towing equipment to avoid possible damage to the
vehicle during towing
operation. Towing is in accordance with Towing Procedure Manual at dealer.
...
B210F shift position/clutch interlock switch
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC B210F is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to PCS-
30, "DTC Logic".
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Shift selector lever to the P position.
2. Turn ign ...
Additional service when replacing ECM
Description
When replacing ECM, this procedure must be performed.
Work Procedure
1.PRECONDITIONING
• Connect a CONSULT-III
• Connect a battery charger
• Electric load switch is OFF
• Wait for the engine to cool [engine coolant temperature < 60?°C (140?°F) and air
temperature < 50?°C ( ...