Nissan Juke Service and Repair Manual : Keyfob battery
Component Function Check
1.CHECK FUNCTION
Check door lock and unlock operation with keyfob button.
Is the inspection result normal? YES >> Keyfob is OK.
NO >> Refer to DLK-528, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK KEYFOB BATTERY
Check by connecting a resistance (approximately 300 Ω) so that the current value becomes about 10 mA.
Standard : Approx. 2.5 - 3.0 V
Is the measurement value within the specification? YES >> Replace keyfob.
NO >> Replace keyfob battery. Refer to DLK-603, "Removal and Installation".
Key switch
Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “KEY ON SW” in “DATA MONITOR” mode. 3. Check that the function operates normally according to ...Remote keyless entry receiver
Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “KEYLESS ” or “KEYLESS UNLOCK” in “DATA MONITOR” mode. 3. Check that the function operates nor ...Other materials:
CD/USB memory care and cleaning
CD
• Handle a CD by its edges. Never touch the surface of the disc. Do not bend
the disc.
• Always place the discs in the storage case when they are not being used.
• To clean a disc, wipe the surface from the center to the outer edge using a clean,
soft cloth. Do not wipe the disc us ...
B1068, B1073 passenger air bag module
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...
Battery terminal with fusible link
Exploded View
1 : Battery terminal with fusible link
2 : Harness connector
: N·m (kg-m, ft-lb)
Removal and Installation
REMOVAL
1. Disconnect the battery cable from the negative terminal.
2. Remove cover of battery positive terminal.
3. Remove harness mounting nut and battery terminal with ...