Nissan Juke Service and Repair Manual : Key switch
Component Function Check
1.CHECK FUNCTION
1. Select “DOOR LOCK” of “BCM” using CONSULT-III.
2. Select “KEY ON SW” in “DATA MONITOR” mode.
3. Check that the function operates normally according to the following conditions.
Is the inspection result normal? YES >> Key switch is OK.
NO >> Refer to DLK-526, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK FUSE
1. Turn ignition switch OFF.
2. Check 10 A fuse, [No.7, located in fuse block (J/B)].
Is fuse fusing? YES >> Replace the blown fuse after repairing the affected circuit if a fuse is blown.
NO >> GO TO 2.
2.CHECK KEY SWITCH POWER SUPPLY CIRCUIT
1. Disconnect key switch connector.
2. Check voltage between key switch harness connector and ground.
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace harness.
3.CHECK KEY SWITCH CIRCUIT
1. Disconnect BCM connector.
2. Check continuity between key switch harness connector and BCM harness connector.
3. Check continuity between key switch connector and ground.
Is the inspection result normal? YES >> GO TO 4 NO >> Repair or replace harness.
4.CHECK KEY SWITCH
Refer to DLK-527, "Component Inspection".
Is the inspection result normal? YES >> GO TO 5.
NO >> Replace key switch.
5.CHECK INTERMITTENT INCIDENT
Refer to GI-42, "Intermittent Incident".
>> INSPECTION END
Component Inspection
COMPONENT INSPECTION
1.CHECK KEY SWITCH
1. Turn ignition switch OFF.
2. Disconnect key switch connector.
3. Check continuity between key switch terminals.
Is the inspection result normal? YES >> INSPECTION END
NO >> Replace key switch.
Hazard function
Component Function Check 1.CHECK FUNCTION 1. Select “MULTI REMOTE ENT” of “BCM” using CONSULT-III. 2. Select “FLASHER” in “ACTIVE TEST” mode. 3. Check that the function operates normally according ...Keyfob battery
Component Function Check 1.CHECK FUNCTION Check door lock and unlock operation with keyfob button. Is the inspection result normal? YES >> Keyfob is OK. NO >> Refer to DLK-528, &q ...Other materials:
Ecu diagnosis information
TCM
Reference Value
CONSULT-III DATA MONITOR STANDARD VALUE
• In CONSULT-III, electric shift timing or lock-up timing, i.e. operation
timing of each solenoid valve, is displayed.
Therefore, if there is an obvious difference between the shift timing estimated
from a shift shock (or
engine ...
Rear disc brake
Brake pad : Inspection and Adjustment
INSPECTION
Check brake pad wear thickness from an inspection hole on cylinder
body. Check using a scale if necessary.
Wear thickness : Refer to BR-71, "Rear Disc Brake".
ADJUSTMENT
Burnish contact surfaces between disc rotor and brake pads acco ...
Information display (ASCD)
Component Function Check
1.CHECK INFORMATION DISPLAY
1. Start engine.
2. Press ASCD MAIN switch.
3. Drive the vehicle at more than 30 km/h (20 MPH)
CAUTION:
Always drive vehicle at a safe speed.
4. Press SET/ACCELERATE or SET/COAST switch.
5. Check that the readings of the speedometer show t ...