Nissan Juke Service and Repair Manual : Key switch
Component Function Check
1.CHECK FUNCTION
1. Select “DOOR LOCK” of “BCM” using CONSULT-III.
2. Select “KEY ON SW” in “DATA MONITOR” mode.
3. Check that the function operates normally according to the following conditions.
Is the inspection result normal? YES >> Key switch is OK.
NO >> Refer to DLK-401, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK FUSE
1. Turn ignition switch OFF.
2. Check 10 A fuse, [No.7, located in fuse block (J/B)].
Is fuse fusing? YES >> Replace the blown fuse after repairing the affected circuit if a fuse is blown.
NO >> GO TO 2.
2.CHECK KEY SWITCH POWER SUPPLY CIRCUIT
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace harness.
3.CHECK KEY SWITCH CIRCUIT
1. Disconnect BCM connector.
2. Check continuity between key switch harness connector and BCM harness connector.
3. Check continuity between key switch connector and ground.
Is the inspection result normal? YES >> GO TO 4 NO >> Repair or replace harness.
4.CHECK KEY SWITCH
Refer to DLK-402, "Component Inspection".
Is the inspection result normal? YES >> GO TO 5.
NO >> Replace key switch.
5.CHECK INTERMITTENT INCIDENT
Refer to GI-42, "Intermittent Incident".
>> INSPECTION END
Component Inspection
COMPONENT INSPECTION
1.CHECK KEY SWITCH
1. Turn ignition switch OFF.
2. Disconnect key switch connector.
3. Check continuity between key switch terminals.
Is the inspection result normal? YES >> INSPECTION END
NO >> Replace key switch.
Hazard function
Component Function Check 1.CHECK FUNCTION 1. Select “MULTI REMOTE ENT” of “BCM” using CONSULT-III. 2. Select “FLASHER” in “ACTIVE TEST” mode. 3. Check that the function operates normally according ...Keyfob battery
Component Function Check 1.CHECK FUNCTION Check door lock and unlock operation with keyfob button. Is the inspection result normal? YES >> Keyfob is OK. NO >> Refer to DLK-403, &q ...Other materials:
Component parts
Component Parts Location
1. A/C auto amp
Refer to HAC-12, "Component Parts
Location"
2. ECM
Refer to EC-25, "ENGINE CONTROL
SYSTEM :
Component Parts Location"
3. TCM
Refer to TM-314, "CVT CONTROL
SYSTEM : Component Parts Location"
4. EPS control unit
Refer ...
Reservoir tank cap
Inspection
• Check valve seat of reservoir tank cap.
- Check if valve seat (A) is swollen to the extent that the edge of the
metal plunger (B) cannot be seen when watching it vertically from
the top.
- Check if valve seat has no soil and damage.
• Pull negative-pressure valve to open it, a ...
Inspection
OIL LEAKAGE
Check transfer surrounding area (oil seal, drain plug, filler plug, and
transfer case etc.) for oil leakage.
OIL LEVEL
1. Remove filler plug (1) and gasket. Then check that oil is filled up
from mounting hole for the filler plug.
Vehicle front
CAUTION:
Never start engine while ...