Nissan Juke Owners Manual : Key positions

LOCK (0)

The key can only be removed from the ignition switch at this position.

OFF (1)

The engine is turned off. The power supply is turned off.

ACC (2)

The electrical accessory power activates without the engine turned on.

ON (3)

The ignition system and the electrical accessory power activate without the engine turned on.

START (4)

The engine starter activates and the engine will start. The ignition switch, when released, will automatically turn to the ON position.

CAUTION

As soon as the engine has started, release the ignition switch immediately.

    Manual Transmission (MT)
    The ignition switch includes a device that helps prevent accidental removal of the key while driving. The key can only be removed when the ignition switch is in the LOCK position. To turn the ig ...

    Push-button ignition switch (models with Intelligent Key system)
    WARNING Do not operate the push-button ignition switch while driving the vehicle except in an emergency. (The engine will stop when the ignition switch is pushed 3 consecutive times or the igniti ...

    Other materials:

    Door request switch
    Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “REQ SW-DR”, “REQ SW-AS” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Fro ...

    Mixture ratio self-learning value clear
    Description This describes how to erase the mixture ratio self-learning value. For the actual procedure, follow the instructions in “Diagnosis Procedure”. Work Procedure With CONSULT-III 1. Start engine and warm it up to normal operating temperature. 2. Select “SELF-LEARNING CONT” in “WORK S ...

    Front grille
    Exploded View 1. Bumper fascia assembly 2. Front side grille RH 3. Front center grille 4. Emblem 5. Front side grille LH : Pawl Removal and Installation REMOVAL CAUTION: When remove front grilles (1) apply protective tape (A) on the bumper fascia (2) to protect the painted surface fr ...