Nissan Juke Owners Manual : Intelligent Key battery discharge

If the battery of the Intelligent Key is discharged, or environmental conditions


If the battery of the Intelligent Key is discharged, or environmental conditions interfere with the Intelligent Key operation, start the engine according to the following procedure:

1. Move the shift lever to the P (Park) position (for Continuously Variable Transmission models) or the shift lever to the N (Neutral) position (for manual transmission models).

2. Firmly apply the foot brake.

3. Touch the ignition switch with the Intelligent Key as illustrated. (A chime will sound.)
4. Push the ignition switch while depressing the brake pedal within 10 seconds after the chime sounds. The engine will start.

After step 3 is performed, when the ignition switch is pushed without depressing the brake pedal, the ignition switch position will change to ACC.

NOTE:

• When the ignition switch is pushed to the ACC or ON position or the engine is started by the above procedures, the Intelligent Key system warning light may blink in yellow even if the Intelligent Key is inside the vehicle. This is not a malfunction. To stop the warning light from blinking, touch the ignition switch with the Intelligent Key again.

•  If the Intelligent Key system warning light in the meter is blinking in green, replace the battery as soon as possible.

(See “Key battery replacement” (P.8- 22).)

    Emergency engine shut off
    To shut off the engine in an emergency situation while driving, perform the following procedure: • Rapidly push the push-button ignition switch 3 consecutive times in less than 1.5 seconds, or • ...

    Before starting the engine
    • Make sure the area around the vehicle is clear. • Check fluid levels such as engine oil, coolant, brake fluid, and window washer fluid as frequently as possible, or at least whenever you refuel ...

    Other materials:

    Front disc brake
    Brake pad : Exploded View MR16DDT 1. Cylinder body 2. Inner shim 3. Inner pad (with pad wear sensor) 4. Pad retainer 5. Torque member 6. Outer pad 7. Outer shim 1: Apply MOLYKOTE® AS880N or silicone-based grease. 2: Apply MOLYKOTE® 7439 or equivalent. : N·m (kg-m, ft-lb) HR16DE ...

    B27B0 A/C auto AMP.
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC is displayed along with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to HAC- 141, "DTC Logic". • If DTC is displayed along with DTC U1010, first perform the trouble diagnosis for DTC U1010. HAC-142, "DTC Log ...

    Seat belt buckle switch signal circuit (driver side)
    Component Function Check 1.CHECK COMBINATION METER INPUT SIGNAL Select the “Data Monitor” for the “METER/M&A” and check the “BUCKLE SW” monitor value. BUCKLE SW When driver seat belt is fastened : Off When driver seat belt is unfastened : On >> INSPECTION END Diagnosis Procedure ...