Nissan Juke Service and Repair Manual : Intelligent key battery
Removal and Installation
1. Release the lock knob at the back of the Intelligent Key and remove the mechanical key.
2. Insert a flat-blade screwdriver (A) wrapped with a cloth into the slit of the corner and twist it to separate the upper part from the lower part.
CAUTION:
• Do not touch the circuit board or battery terminal.
• The key fob is water-resistant. However, if it does get wet, immediately wipe it dry.
3. Replace the battery with new one.
Battery replacement :Coin-type lithium battery (CR2025)
4. Align the tips of the upper and lower parts, and then push them together until it is securely closed.
CAUTION:
• When replacing battery, keep dirt, grease, and other foreign
materials off the electrode contact area.
• After replacing the battery, check that all Intelligent Key functions work normally.
Remote keyless entry receiver
Removal and Installation REMOVAL 1. Remove the glove box assembly. Refer to IP-13, "Removal and Installation". 2. Remove the remote keyless entry receiver (1) mounting bolt (A), and th ...Other materials:
B2193 chain of ECM-IMMU
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B2193 is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to
BCS-83, "DTC Logic".
• If DTC B2193 is displayed with DTC U1010, first perform the trouble diagnosis
for DTC U1010. Refer to
BCS-84, "D ...
B1183 lap Pre-tensioner LH
DTC Logic
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAGNOSTIC RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp status. Refer to SRC ...
Thermo plunger unit
Exploded View
1. Side member LH
2. Thermo plunger control unit
3. Thermo plunger relay
4. Thermo plunger connector
5. Earth lead
6. Thermo plunger unit
7. Bracket stay
Vehicle front
: N·m (kg-m, in-lb)
Removal and Installation
REMOVAL
1. Remove battery cable from the negative ter ...