Nissan Juke Service and Repair Manual : Intelligent key

Component Function Check

1.CHECK FUNCTION

1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III.

2. Select “RKE OPE COUN1” in “DATA MONITOR” mode.

3. Check that the function operates normally according to the following conditions.

Is the inspection result normal?


Is the inspection result normal? YES >> Intelligent Key is OK.

NO >> Refer to DLK-262, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK INTELLIGENT KEY BATTERY

Check by connecting a resistance (approximately 300 Ω) so that the current value becomes about 10 mA. Refer to DLK-356, "Removal and Installation".

Standard : Approx. 2.5 - 3.0 V

Is the measurement value within the specification? YES >> Replace Intelligent Key.

NO >> Replace Intelligent Key battery.

Intelligent key warning buzzer


    Hazard function
    Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “FLASHER” in “ACTIVE TEST” mode. 3. Check that the function operates normally according ...

    Intelligent key warning buzzer
    Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “OUTSIDE BUZZER” in “ACTIVE TEST” mode. 3. Check that the function operates normally acc ...

    Other materials:

    Luggage floor trim
    Exploded View 2WD models 1. Rear pillar cap RH 2. Luggage side upper finisher RH 3. Luggage side lower finisher RH 4. Luggage floor board 5. Luggage side upper finisher LH 6. Rear pillar cap LH 7. Luggage side lower finisher LH 8. Seat belt hook LH 9. Shock absorber mask LH 10. Lug ...

    S terminal circuit
    Description The output voltage of the alternator is controlled by the IC voltage regulator at the “S” terminal detecting the input voltage. The “S” terminal circuit detects the battery voltage to adjust the alternator output voltage with the IC voltage regulator. Diagnosis Procedure 1.CH ...

    Diagnosis and repair work flow
    Flowchart of Trouble Diagnosis NOTE: “DTC” includes DTC at the 1st trip. 1.OBTAIN INFORMATION ABOUT SYMPTOM 1. Refer to TM-372, "Question sheet" and interview the customer to obtain the malfunction information (conditions and environment when the malfunction occurred) as much as p ...