Nissan Juke Service and Repair Manual : Intake sensor
Exploded View
Refer to HA-43, "Exploded View (Automatic Air Conditioning)". (HR16DE) Refer to HA-97, "Exploded View (Automatic Air Conditioning)". (MR16DDT)
Removal and Installation
REMOVAL
1. Remove evaporator.
• Refer to HA-55, "EVAPORATOR : Removal and Installation". (HR16DE) • Refer to HA-115, "EVAPORATOR : Removal and Installation". (MR16DDT)
2. Remove intake sensor from evaporator.
INSTALLATION
Note the following items, and then install in the order of removal.
CAUTION:
• Replace O-rings with new ones. Then apply the compressor oil to them when
installing.
• Mark the mounting position of intake sensor bracket prior to removal so that the reinstalled sensor can be located in the same position.
• Never rotate the bracket insertion part when removing and installing the intake sensor.
• Check for leakages when recharging refrigerant. Refer to HA-19, "Leak Test". (HR16DE) or HA-74, "Leak Test". (MR16DDT
)
Sunload sensor
Removal and Installation REMOVAL 1. Remove switch panel. Refer to IP-13, "Removal and Installation". 2. Disconnect sunload sensor connector, and then remove sunload sensor. INSTALLATIO ...Refrigerant pressure sensor
Exploded View Refer to HA-39, "Exploded View". (HR16DE) Refer to HA-94, "Exploded View". (MR16DDT) Removal and Installation REMOVAL Refer to HA-42, "REFRIGERANT PRESSURE ...Other materials:
Basic inspection
Diagnosis and repair workflow
Trouble Diagnosis Flow Chart
Trouble Diagnosis Procedure
INTERVIEW WITH CUSTOMER
Interview with the customer is important to detect the root cause of CAN
communication system errors and to
understand vehicle condition and symptoms for proper trouble diagnosis.
...
Diagnosis system (ECM)
Diagnosis description
Diagnosis description : 1st Trip Detection
Logic and Two Trip Detection Logic
When a malfunction is detected for the first time, 1st trip DTC and 1st trip
Freeze Frame data are stored in the
ECM memory. The MIL will not illuminate at this stage. <1st trip>
If the s ...
B1113, B1114 satellite sensor RH
DTC Logic
DTC DETECTION LOGIC
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp status. Refer to SRC-12, "On ...