Nissan Juke Service and Repair Manual : Intake sensor

Exploded View

Refer to HA-97, "Exploded View (Automatic Air Conditioning)".

Removal and Installation

REMOVAL

1. Remove evaporator assembly. Refer to HA-115, "EVAPORATOR : Removal and Installation".

2. Remove intake sensor from evaporator.

INSTALLATION

Note the following items, and then install in the order of removal.

CAUTION:
• Replace O-rings with new ones. Then apply the compressor oil to them when installing.

• Mark the mounting position of intake sensor bracket prior to removal so that the reinstalled sensor can be located in the same position.

• Never rotate the bracket insertion part when removing and installing the intake sensor.

• Check for leakages when recharging refrigerant. Refer to HA-74, "Leak Test".

    Sunload sensor
    Removal and Installation REMOVAL 1. Remove switch panel. Refer to IP-13, "Removal and Installation". 2. Disconnect sunload sensor connector, and then remove sunload sensor. INSTALLATIO ...

    Refrigerant pressure sensor
    Exploded View Refer to HA-94, "Exploded View". Removal and Installation REMOVAL Refer to HA-96, "REFRIGERANT PRESSURE SENSOR : Removal and Installation". INSTALLATION Insta ...

    Other materials:

    P0711 transmission fluid temperature sensor A
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2.PERFORM DTC CONFIRMATION ...

    Passenger side door mirror defogger
    Description Heats the heating wire with the power supply from the rear window defogger relay to prevent the door mirror from fogging up. Component Function Check 1.CHECK PASSENGER SIDE DOOR MIRROR DEFOGGER 1. Perform IPDM E/R Active Test (“REAR DEFOGGER”) using CONSULT-III. 2. Touch “ON”. 3 ...

    Back door opener switch
    Component Function Check 1.CHECK FUNCTION 1. Select “TRUNK” of “BCM” using CONSULT-III. 2. Select “TRNK OPNR SW” in “DATA MONITOR” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? YES >> Back door opener switch ...