Nissan Juke Service and Repair Manual : Inspection
INSPECTION AFTER REMOVAL
Check the following items, and replace the part if necessary.
• Move joint up/down, left/right, and in the axial directions. Check for motion that is not smooth and for significant looseness.
• Check boot for cracks, damage, and leakage of grease.
• Check the support bearing bracket for cracks, deformation and other damage.
INSPECTION AFTER DISASSEMBLY
Check the following items, and replace the part if necessary.
Dynamic Damper
Check damper for cracks or wear.
Joint Sub-Assembly
Check the following:
• Joint sub-assembly for rough rotation and excessive axial looseness.
• The inside of the joint sub-assembly for entry of foreign material.
• Joint sub-assembly for compression scars, cracks, and fractures inside of joint sub-assembly.
Replace joint sub-assembly if there are any non-standard conditions of components.
Housing assembly
• Replace housing assembly if there is scratching or wear of housing assembly
roller contact surface.
• Check shaft for runout, cracks, or other damage.
Support Bearing (Right Side) Check bearing rolls freely and is free from noise, cracks, pitting or wear. Replace support bearing if there are any non-standard conditions.
Support Bearing Bracket (Right Side) Check for support bearing bracket, cracks, or damage. Replace support bearing bracket if there are any nonstandard conditions.
INSPECTION AFTER INSTALLATION
1. Check wheel sensor harness for proper connection. Refer to BRC-84, "FRONT WHEEL SENSOR : Exploded View" (Without ESP) or BRC-224, "FRONT WHEEL SENSOR : Exploded View" (With ESP).
2. Check the wheel alignment. Refer to FSU-7, "Inspection".
Front drive shaft
Exploded View LEFT SIDE 1. Circular clip 2. Dust shield 3. Housing assembly 4. Boot band 5. Boot 6. Damper band 7. Dynamic damper 8. Circular clip 9. Joint sub-assembly : Wheel side ...Service data and specifications (SDS)
Wheel Bearing Drive Shaft 2WD *: For measuring position, refer to FAX-26, "WHEEL SIDE : Disassembly and Assembly" (Wheel side), FAX- 29, "TRANSAXLE SIDE : Disassembly and Asse ...Other materials:
Key interlock cable
Exploded View
1. CVT shift selector assembly
2. Key interlock cable
A: Key cylinder
B: Clip
C: Clip
Removal and Installation
REMOVAL
CAUTION:
Always apply the parking brake before performing removal and installation.
1. Shift the selector lever to the “P” position.
2. Remove the sele ...
Component parts
Component Parts Location
1. Light & rain sensor*1
2. Combination switch
3. Combination meter
4. BCM
Refer to BCS-6, "BODY CONTROL
SYSTEM : Component Parts Location".
5. IPDM E/R
Refer to PCS-5, "Component Parts
Location" (with Intelligent Key system)
or PCS-37, ...
System (intelligent key system)
Intelligent key system : System Diagram
Intelligent key system : System Description
• The Intelligent Key system is a system that makes it possible to lock and
unlock the door locks (door lock/
unlock function) by carrying the Intelligent Key, which operates based on the
results of electron ...