Nissan Juke Service and Repair Manual : Inspection
OIL LEAKAGE
Check rear final drive surrounding area (oil seal, drain plug, filler plug, and carrier case, etc.) for oil leakage.
OIL LEVEL
1. Remove filler plug (1) and check oil level from filler plug mounting hole as shown in the figure.
CAUTION:
Never start engine while checking oil level.
2. Set a new gasket on filler plug and install it on final drive assembly.
Refer to DLN-151, "Exploded View".
CAUTION:
Never reuse gasket.
Periodic maintenance
REAR DIFFERENTIAL GEAR OIL ...Draining
1. Stop engine. 2. Remove drain plug (1) and drain gear oil. 3. Set a new gasket on drain plug and install it to final drive assembly and tighten to the specified torque. Refer to DLN-151, "E ...Other materials:
Cooler pipe and hose
Exploded View
1. A/C unit assembly
2. O-ring
3. High-pressure pipe
4. O-ring
5. Low-pressure flexible hose
6. High-pressure flexible hose
7. O-ring
8. Condenser
9. Compressor
: Do not reuse
: N·m (kg-m, in-lb)
: N·m (kg-m, ft-lb)
High-pressure flexible hose : Removal and Installa ...
P182F coupling temperature sensor left
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.DTC REPRODUCTION PROCEDURE
With ...
Air conditioning system refrigerant and lubricant recommendations
The air conditioning system in your NISSAN vehicle must be charged with the
refrigerant HFC-134a (R-134a) and the oil, NISSAN A/C system oil Type R or the exact
equivalents.
CAUTION
The use of any other refrigerant or oil will cause severe damage to the air
conditioning system and will requi ...