Nissan Juke Service and Repair Manual : Inside key antenna
Instrument center
INSTRUMENT CENTER : Removal and Installation
REMOVAL
1. Remove the multi display unit. Refer to AV-125, "Removal and Installation".
2. Remove the inside key antenna (instrument center) (1) mounting clip (A), and then remove inside key antenna (instrument center).
CAUTION:
Be careful not to drop mounting clip (A) into instrument
panel.
INSTALLATION
Install in the reverse order of removal.
Console
CONSOLE : Removal and Installation
REMOVAL
1. Remove the center console assembly. Refer to IP-23, "Removal and Installation".
2. Remove the inside key antenna (console) (1) mounting clip (A), and then remove inside key antenna (console).
INSTALLATION
Install in the reverse order of removal.
Luggage room
LUGGAGE ROOM : Exploded View
1. Inside key antenna (luggage room) 2. Clip
: Do not reuse
LUGGAGE ROOM : Removal and Installation
REMOVAL
1. Remove the luggage floor finisher. Refer to INT-29, "Exploded View".
2. Remove the inside key antenna (luggage room) (1) mounting clip RH (A).
3. Disengage inside key antenna (luggage room) fixing clip using a flat-bladed screwdriver (A), and then pull out forward the inside key antenna (luggage room).
INSTALLATION
Install in the reverse order of removal.
CAUTION:
Visually check the clips for deformation and damage during installation.
Replace with new ones if necessary.
Door switch
Exploded View 1. Door switch 2. TORX bolt Removal and Installation REMOVAL Remove the TORX bolt (A), and then remove door switch (1). INSTALLATION Install in the reverse order of removal. ...Outside key antenna
Driver side DRIVER SIDE : Removal and Installation REMOVAL Remove the driver side outside handle. Refer to DLK-176, "OUTSIDE HANDLE : Removal and Installation". INSTALLATION Install ...Other materials:
Symptom diagnosis
Squeak and rattle trouble diagnoses
Work Flow
CUSTOMER INTERVIEW
Interview the customer if possible, to determine the conditions that exist
when the noise occurs. Use the Diagnostic
Worksheet during the interview to document the facts and conditions when the
noise occurs and any of
the cu ...
Hazard reminder operation does not operate
Diagnosis Procedure
1.CHECK DTC WITH BCM AND COMBINATION METER
Check that DTC is not detected with BCM and combination meter.
Is the inspection result normal?
YES >> GO TO 2.
NO-1 >> Refer to BCS-141, "DTC Index". (BCM)
NO-2 >> Refer to MWI-36, "DTC Index&q ...
Hood lock
Exploded View
1. Hood lock control cable assembly
2. Hood lock assembly
: Clip
: N·m (kg-m, ft-lb)
: Body grease
Hood lock
HOOD LOCK : Removal and Installation
REMOVAL
1. Remove front center grille. Refer to EXT-18, "Removal and Installation".
2. Remove crash zone sensor. Refe ...