Nissan Juke Service and Repair Manual : Input shaft and gear

Exploded View

1. Input shaft front bearing


1. Input shaft front bearing 2. Input shaft
3. Snap ring
4. Input shaft rear bearing 5. Adapter plate
6. Bushing
7. 5th input gear
8. 5th-reverse baulk ring 9. Synchronizer lever
10. 5th-reverse synchronizer hub 11. 5th-reverse coupling sleeve 12. Retaining pin
13. Reverse gear

: Replace the parts as a set.: Apply gear oil.


: Always replace after every: Replace the parts as a set.


disassembly.: Always replace after every
disassembly.

Disassembly: N·m (kg-m, ft-lb)


Disassembly

Refer to TM-37, "Disassembly" for disassembly procedure.

Assembly

Refer to TM-43, "Assembly" for assembly procedure.

Inspection

INSPECTION AFTER DISASSEMBLY

Input Shaft and Gear

Check the following items and replace if necessary.

• Damage, peeling, bend, uneven wear, and distortion of shaft.

• Excessive wear, damage, and peeling of gear.

Synchronizer Hub and Coupling Sleeve


Synchronizer Hub and Coupling Sleeve Check the following items and replace if necessary.

• Breakage, damage, and unusual wear on contact surface of coupling sleeve, synchronizer hub, and insert key.

• Coupling sleeve and synchronizer hub move smoothly.

Baulk RingBaulk Ring


Baulk RingBaulk Ring Check contact surface of baulk ring cam and insert key for excessive wear, uneven wear, bend, and damage. Replace if necessary.

Check contact surface of baulk ring cam and insert key for excessive wear, uneven wear, bend, and damage. Replace if necessary.

Bearing


Bearing
Check bearing for damage and unsmooth rotation. Replace if necessary.

Mainshaft and gear


    Transaxle assembly
    Exploded View CASE AND HOUSING 1. Differential side oil seal 2. Clutch housing 3. 2 way connector 4. Oil gutter 5. Air breather inner tube 6. Filler plug 7. Gasket 8. Transaxle case 9 ...

    Mainshaft and gear
    Exploded View 1. Mainshaft front bearing outer race 2. Mainshaft front bearing inner race 3. Mainshaft 4. 1st main gear 5. 1st inner baulk ring 6. 1st synchronizer cone 7. 1st outer baulk ...

    Other materials:

    Exterior lighting system symptoms
    Without daytime running light system WITHOUT DAYTIME RUNNING LIGHT SYSTEM : Symptom Table CAUTION: Perform the self-diagnosis with CONSULT-III before the symptom diagnosis. Perform the trouble diagnosis if any DTC is detected. With daytime running light system WITH DAYTIME RUNNING LIGHT ...

    Blower fan on signal
    Component Function Check 1.CHECK BLOWER FAN ON SIGNAL With CONSULT-III 1. Turn ignition switch ON. 2. Select “AIR CONDITIONER” of “BCM” using CONSULT-III. 3. Select “FAN ON SIG” in “DATA MONITOR” mode, and check status under the following condition. Is the inspection result normal? YES &g ...

    Fuel level sensor unit
    Exploded View 1. Lock ring 2. Fuel level sensor unit 3. Seal packing A. To fuel tank : Always replace after every disassembly Removal and Installation WARNING: Read “General Precautions” when working on the fuel system. Refer to FL-45, "General Precautions". REMOVAL 1. Ch ...