Nissan Juke Service and Repair Manual : Information display (speed limiter)
Component Function Check
1.CHECK INFORMATION DISPLAY (SPEED LIMITER) FUNCTION
1. Start engine.
2. Press speed limiter MAIN switch.
3. Drive the vehicle at more than 30 km/h (20 MPH).
CAUTION:
Always drive vehicle at a safe speed.
4. Press SET/COAST switch.
5. Perform a test drive on a flat road conditions. Check that the speedometer indicated the same value as the set speed indicator on the information display while depressing the accelerator pedal until just before a kickdown occurs.
Is the inspection result normal? YES >> INSPECTION END
NO >> Go to EC-788, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK DTC
Check that DTC UXXXX, P0500 or P1574 is not display.
Is the inspection result normal? YES >> GO TO 2.
NO-1 >> Perform trouble diagnosis for DTC UXXXX.
NO-2 >> Perform trouble diagnosis for DTC P0500. Refer to EC-673, "Diagnosis Procedure".
NO-3 >> Perform trouble diagnosis for DTC P1574. Refer to EC-723, "Diagnosis Procedure".
2.CHECK DTC WITH COMBINATION METER
Check DTC with combination meter. Refer to EC-522, "DTC Index".
Is the inspection result normal? YES >> GO TO 3.
NO >> Perform trouble diagnosis relevant to DTC indicated.
3.CHECK INTERMITTENT INCIDENT
Refer to GI-42, "Intermittent Incident".
Is the inspection result normal? YES >> Replace combination meter.
NO >> Repair or replace.
Ignition signal
Component Function Check 1.INSPECTION START Turn ignition switch OFF, and restart engine. Does the engine start? YES-1 >> With CONSULT-III: GO TO 2. YES-2 >> Without CONSULT-III: ...Malfunction indicator
Component Function Check 1.CHECK MI FUNCTION 1. Turn ignition switch ON. 2. Make sure that MI lights up. Is the inspection result normal? YES >> INSPECTION END NO >> Go to EC-789, ...Other materials:
Illumination
Wiring Diagram
For connector terminal arrangements, harness layouts, and alphabets in a
(option abbreviation: if not
described in wiring diagram), refer to GI-12, "Connector Information/Explanation
of Option Abbreviation".
...
Brake warning lamp
Component Function Check
1.CHECK BRAKE WARNING LAMP FUNCTION (1)
Check that brake warning lamp in combination meter turns ON for approx. 1
second after ignition switch is
turned ON.
CAUTION:
Never start engine.
Is the inspection result normal?
YES >> GO TO 2.
NO >> Proceed ...
All defogger system dose not operate
Description
Rear window defogger and door mirror defogger do not operate when rear window
defogger switch operated.
Diagnosis Procedure
1.CHECK REAR WINDOW DEFOGGER SWITCH
Check rear window defogger switch.
Refer to DEF-26, "WITH AUTO A/C : Component Function Check" (With Auto A/C ...