Nissan Juke Service and Repair Manual : Information display (speed limiter)

Component Function Check

1.CHECK INFORMATION DISPLAY (SPEED LIMITER) FUNCTION

1. Start engine.

2. Press speed limiter MAIN switch.

3. Drive the vehicle at more than 30 km/h (20 MPH).

CAUTION:
Always drive vehicle at a safe speed.

4. Press SET/− switch.

5. Perform a test drive on a flat road conditions. Check that the speedometer indicated the same value as the set speed indicator on the information display while depressing the accelerator pedal until just before a kickdown occurs.

Is the inspection result normal? YES >> INSPECTION END

NO >> Proceed to EC-435, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK DTC

Check that DTC UXXXX, P0500 or P1574 is not displayed.

Is the inspection result normal? YES >> GO TO 2.

NO-1 >> Perform trouble diagnosis for DTC UXXXX.

NO-2 >> Perform trouble diagnosis for DTC P0500. Refer to EC-286, "DTC Logic".

NO-3 >> Perform trouble diagnosis for DTC P1574. Refer to EC-352, "DTC Logic".

2.CHECK DTC WITH COMBINATION METER

Refer to MWI-23, "CONSULT-III Function".

Is the inspection result normal? YES >> GO TO 3.

NO >> Perform trouble diagnosis for DTC indicated.

3.CHECK INTERMITTENT INCIDENT

Perform GI-42, "Intermittent Incident".

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-69, "Removal and Installation".

NO >> Repair or replace error-detected parts.

    Information display (ASCD)
    Component Function Check 1.CHECK INFORMATION DISPLAY 1. Start engine. 2. Press ASCD MAIN switch on ASCD steering switch. 3. Drive the vehicle at more than 40 km/h (25 MPH). CAUTION: Always dri ...

    Malfunction indicator lamp
    Component Function Check 1.CHECK MIL FUNCTION 1. Turn ignition switch ON. 2. Check that MIL lights up. Is the inspection result normal? YES >> INSPECTION END NO >> Proceed to EC-43 ...

    Other materials:

    P17B4 low brake solenoid
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PREPARATION BEFORE WORK If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test. >> GO TO 2. 2.CHECK DTC DETECTION 1. S ...

    Cleaning
    If your windshield is not clear after using the windshield washer or if a wiper blade chatters when running, wax or other material may be on the blade or windshield. Clean the outside of the windshield with a washer solution or a mild detergent. Your windshield is clean if beads do not form whe ...

    Flushing
    1. Install radiator drain plug. CAUTION: Be sure to clean drain plug and install with new O-ring. Radiator drain plug : Refer to CO-17, "Exploded View". • If water drain plugs on cylinder block are removed, close and tighten them. Refer to EM-63, "Setting". 2. Remove a ...