Nissan Juke Service and Repair Manual : Information display (ASCD)

Component Function Check

1.CHECK INFORMATION DISPLAY

1. Start engine.

2. Press ASCD MAIN switch on ASCD steering switch.

3. Drive the vehicle at more than 40 km/h (25 MPH).

CAUTION:
Always drive vehicle at a safe speed.

4. Press SET/− switch.

5. Check that the reading of the speedometer shows the same value as the set speed indicated in the information display while driving the vehicle on a flat road.

Is the inspection result normal? YES >> INSPECTION END

NO >> Proceed to EC-434, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK DTC

Check that DTC UXXXX, P0500 or P1574 is not displayed.

Is the inspection result normal? YES >> GO TO 2.

NO-1 >> Perform trouble diagnosis for DTC UXXXX.

NO-2 >> Perform trouble diagnosis for DTC P0500. Refer to EC-286, "DTC Logic".

NO-3 >> Perform trouble diagnosis for DTC P1574. Refer to EC-352, "DTC Logic".

2.CHECK DTC WITH COMBINATION METER

Refer to MWI-23, "CONSULT-III Function".

Is the inspection result normal? YES >> GO TO 3.

NO >> Perform trouble diagnosis for DTC indicated.

3.CHECK INTERMITTENT INCIDENT

Perform GI-42, "Intermittent Incident".

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-69, "Removal and Installation".

NO >> Repair or replace error-detected parts.

    SPEED LIMITER MAIN SWITCH
    Component Function Check 1.CHECK SPEED LIMITER MAIN SWITCH FUNCTION With CONSULT-III 1. Turn ignition switch ON. 2. Select “SL MAIN SW” in “DATA MONITOR” mode of “ENGINE” using CONSULT-III. 3. Ch ...

    Information display (speed limiter)
    Component Function Check 1.CHECK INFORMATION DISPLAY (SPEED LIMITER) FUNCTION 1. Start engine. 2. Press speed limiter MAIN switch. 3. Drive the vehicle at more than 30 km/h (20 MPH). CAUTION: ...

    Other materials:

    High pressure fuel pump and fuel hose
    Exploded View CAUTION: Never remove or disassemble parts unless instructed as shown in the figure. 1. High pressure fuel pump insulator 2. High pressure fuel pump 3. O-ring 4. Valve lifter 5. Fuel tube assembly 6. Bracket 7. Fuel pump connector protector 8. Fuel feed hose A. To ce ...

    Front drive shaft boot
    Exploded View LEFT SIDE 1. Circular clip 2. Dust shield 3. Housing assembly 4. Boot band 5. Boot 6. Damper band 7. Dynamic damper 8. Circular clip 9. Joint sub-assembly : Wheel side : Fill NISSAN Genuine grease or equivalent. : Always replace after every disassembly. RIGHT ...

    Normal operating condition
    Description FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED) If the engine speed is above 1,800 rpm under no load (for example, the selector lever position is neutral and engine speed is over 1,800 rpm) fuel will be cut off after some time. The exact time when the fuel is cut off varies b ...