Nissan Juke Service and Repair Manual : Information display (ASCD)

Component Function Check

1.CHECK INFORMATION DISPLAY

1. Start engine.

2. Press ASCD MAIN switch.

3. Drive the vehicle at more than 30 km/h (20 MPH) CAUTION:
Always drive vehicle at a safe speed.

4. Press SET/ACCELERATE or SET/COAST switch.

5. Check that the readings of the speedometer show the same values as the set speed indicated in the information display while driving the vehicle on a flat road.

Is the inspection result normal? YES >> INSPECTION END

NO >> Go to EC-1017, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK CAN COMMUNICATION LINE

Refer to LAN-31, "CAN COMMUNICATION SYSTEM : CAN Communication Signal Chart".

OK or NG OK >> GO TO 2.

NG >> Repair or replace.

2.CHECK DTC WITH ???UNIFIED METER AND A/C AMP.???

Refer to MWI-23, "CONSULT-III Function".

Is the inspection result normal? YES >> GO TO 3.

NO >> Perform trouble diagnosis relevant to DTC indicated.

3.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident", ???INCIDENT SIMULATION TESTS??? and ???GROUND INSPECTION???.

Is the inspection result normal? YES >> Replace combination meter.

NO >> Repair or replace.

    Cooling fan
    Diagnosis Procedure 1.CHECK GROUND CONNECTION 1. Turn ignition switch OFF. 2. Check ground connection E38. Refer to Ground Inspection in GI-44, "Circuit Inspection". Is the inspectio ...

    Information display (speed limiter))
    Component Function Check 1.CHECK INFORMATION DISPLAY (SPEED LIMITER) FUNCTION 1. Start engine. 2. Press speed limiter MAIN switch. 3. Drive the vehicle at more than 30 km/h (20 MPH). CAUTION: ...

    Other materials:

    B26F9 cranking request circuit
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B26F9 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic". • If DTC B26F9 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to BCS-84, "D ...

    Buzzer (combination meter)
    Component Function Check 1.CHECK FUNCTION 1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III. 2. Select “INSIDE BUZZER” in “ACTIVE TEST” mode. 3. Check that the function operates normally according to the following conditions. Is the inspection result normal? Yes >> Buzzer (combi ...

    Yaw rate/side/decel G sensor
    Exploded View 1. Yaw rate/side/decel G sensor 2. Yaw rate/side/decel G sensor harness connector 3. Bracket : Vehicle front : N·m (kg-m, in-lb) Removal and Installation REMOVAL CAUTION: Never drop or strike yaw rate/side/decel G sensor, because it has little endurance to impact. Never ...