Nissan Juke Service and Repair Manual : In-vehicle sensor
Removal and Installation
REMOVAL
1. Remove instrument lower panel (LH/RH). Refer to IP-13, "Removal and Installation".
2. Remove fixing screw, and then remove in-vehicle sensor from instrument lower panel (LH/RH).
INSTALLATION
Install in the reverse order of removal.
Ambient sensor
Removal and Installation REMOVAL 1. Remove bumper fascia assembly. Refer to EXT-13, "Removal and Installation". 2. Disengage fixing pawl, and then remove ambient sensor (1) from air gu ...Sunload sensor
Removal and Installation REMOVAL 1. Remove switch panel. Refer to IP-13, "Removal and Installation". 2. Disconnect sunload sensor connector, and then remove sunload sensor. INSTALLATIO ...Other materials:
Power supply and ground circuit
Diagnosis Procedure
1.CHECK FUSES AND FUSIBLE LINK
Check that the following IPDM E/R fuses or fusible links are not blown.
Is the fuse fusing?
YES >> Replace the blown fuse or fusible link after repairing the affected
circuit if a fuse or fusible link is
blown.
NO >> GO TO 2. ...
Diagnosis system (bcm) (without intelligent key system)
Common item
COMMON ITEM : CONSULT-III Function (BCM - COMMON ITEM)
APPLICATION ITEM
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the ...
Continuously Variable Transmission (CVT)
The Continuously Variable Transmission (CVT) in your vehicle is electronically
controlled to produce maximum power and smooth operation.
The recommended operating procedures for this transmission are shown on the following
pages.
Follow these procedures for maximum vehicle performance and driv ...