Engine block heater (if so equipped)

Engine block heaters are used to assist in cold temperature starting. The engine block heater should be used when the outside temperature is 208F (−78C) or lower. To use the engine block hea ...

Hazard warning flasher switch

Push the switch on to warn other drivers when you must stop or park under emergency conditions. All turn signal lights will flash. WARNING •  If stopping for an emergency, be sure to move ...

Other materials:

Water pump
Exploded View 1. Gasket 2. Water pump : N·m (kg-m, ft-lb) : Always replace after every disassembly. Removal and Installation REMOVAL 1. Drain engine coolant from radiator. Refer to CO-11, "Draining". CAUTION: • Perform this step when the engine is cold. • Never spill engin ...

Stall test
Work Procedure INSPECTION 1. Check the engine oil level. Replenish if necessary. Refer to LU-25, "Inspection". 2. Check for leak of the CVT fluid. Refer to TM-480, "Inspection". 3. Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 t ...

Water outlet
Exploded View 1. Heater pipe bracket 2. Radiator cap 3. Water outlet adaptor 4. Clamp 5. Water outlet hose 6. Clamp 7. Heater hose 8. Clamp 9. Water outlet 10. Clamp 11. Heater hose 12. Heater hose 13. Clamp 14. Heater hose 15. Clamp 16. Engine coolant temperature sensor ...